Strend Pro 266751 Übersetzung Der Original-Gebrauchsanweisung Seite 28

the respiratory tract. If you experience any problems, consult a doctor.
- A damaged battery that can no longer be charged must be treated as hazardous waste. Do not throw the
battery into the trash, fire or water.
- Charge the battery in a dry environment and ensure that no water gets into the charging adapter. The
charging adapter is intended for use in enclosed spaces only. It must be protected against water ingress and
high humidity.
- Keep the charging adapter clean and do not operate it on easily flammable surfaces or in environments with
a risk of explosion or fire.
- Unplug the charging adapter from the electrical outlet before cleaning.
- Charge the battery only for the time required for charging. The charging process is signaled by the change
of the LED color from red to green.
- Charge the battery within a temperature range of 0-45 °C. Outside this temperature range, allow the battery
to reach ambient temperature before charging outside this range.
- If you are not using the cordless sprayer, close the charging port with the rubber cap. This will prevent dirt
or moisture from entering and prevent a possible short circuit of the battery caused by contact with metal
objects. A short circuit can lead to overheating, fire or burns.
- Protect the cordless sprayer from impacts, moisture, direct sunlight, temperatures higher than 50 °C and
never try to open the battery. If the plastic cover cracks, stop using the cordless sprayer immediately and do
not try to charge it.
- Keep the charging connector, charging adapter port clean and protect them from dirt, damage, or
deformation.
USE
INSPECTION BEFORE USE
- After unpacking, check that the product is not damaged.
- Make sure the battery is charged and that no part of the product is loose or cracked.
CHARGING THE BATTERY
- Connect one end of the charging cable (USB-C type – included) to the charging adapter slot (adapter not
included).
- Plug the other end of the charging cable into the product's charging port.
- Insert the charging adapter into an electrical socket (if the socket has a switch, turn it to the "I" position).
Note: The LED backlight of the ON/OFF switch will glow red while charging.
- The display will show the current battery charge level.
- When the battery is fully charged, the LED backlight of the ON/OFF switch will glow green.
FILLING THE CONTAINER
- Turn the body with the handle counterclockwise and separate it from the spray container.
- Fill the tank with water or a suitable spray - do not exceed the maximum level marked on the tank.
- Screw the body with the handle back clockwise to seal the device tightly.
- Check that there is no liquid leaking from the device and make sure that all connections are properly sealed.