Draining The Condensation Reservoir; Cleaning And Maintenance - Ardo Cdr05L Gebrauchsanweisung

20
DRAINING THE CONDENSATION WATER RESERVOIR
If the condensation drain hose is not connected directly to the drainage system, the
condensation is collected in the reservoir ( g. 11). The reservoir must be emptied after
each drying cycle.
To empty the reservoir, proceed as follows:
▼ Remove the reservoir from the drier (Fig. 11).
▼ Empty the reservoir. The drain hole is located on the top right ( g. 12).
▼ After emptying, replace the container in its housing making sure it is properly
seated.
▼ If the reservoir is not emptied or it  lls up excessively during a drying cycle, the
condensation reservoir warning light will  ash and the drier will stop. If this happens,
proceed as described above.
▼ To restart the programme, press the reservoir alarm reset button (V) ( g. 9).

CLEANING AND MAINTENANCE

Disconnect the drier from the mains supply before cleaning. It is important to clean
the drier after each drying cycle in order to save in drying time and consequently save
energy.
1. Door  uff  lter ( g. 13).
2. Fluff  lter in the loading aperture ( g. 14).
3. Condenser ( g. 15).
▼ Remove the  lter by pulling upwards and then clean it ( g. 13).
▼ It is also possible to remove the two  uff  lters from the door opening and clean
them ( g. 14).
NB. The presence of  uff in the  lter is not the result of the drying procedure.
The  uff comes from the  bres of fabrics damaged or unthreaded during
the wash and, above all, as a result of wear.
The  lters can be cleaned by simply placing them under hot running water.
▼ The condenser should be cleaned two or three times a year ( g. 15/18).
▼ Open the door, rotate the lever to the vertical position and remove the cover ( g.
15).
GB
MAINTENANCE
11
12
13
14
15
SM2258