Technical Specifications - Antari M-30 Bedienungsanleitung

-Transmitter
-Emitting fog
Press the button "A", to emit fog. The button "A" has the same function as the button
VOLUME on the control panel, i e. the fog output depends on the setting of menu item
»Volume Output«. The display indicates »Volume« followed by the defined value or
»NONSTOPBURST« when continuous fog output was selected. As additional control, the
blue LED light. To stop the fog output, press the button "B"
-Note
To operate the machine with a different transmitter than the included one, or to operate it
with up to 5 different transmitters, each transmitter must be registered first. For this
purpose, turn on the machine. When the display indicates »Wireless Detect...«, press the
button "A" 1 second on each transmitter. Thus the previous transmitters are cleared from
the memory of the receiver. The setting must be completed within 15 seconds at indication
»Wireless Detect...«. If no transmitter is registered when the machine is switched on, the
memory of the receiver will keep the record of the previous operation
-Battery change
If the range of the transmitter decreases, the battery is probably exhausted and must be
replaced. For this purpose, screw off the housing cover and remove the used battery.
Insert a fresh 12 V battery type 23A as indicated in the battery compartment and refit the
housing cover.

-Technical Specifications

-Transmitter
Carrier frequency:. . . . . UHF 433.920 MHz
RF power output: . . . . . 10 mW
Range: . . . . . . . . . . . . . approx. 50 m
Battery: . . . . . . . . . . . . . 12 V
-Receiving unit
Compatible with: . . . . . . M-5, M-10
Cable length: . . . . . . . . 2 m
Connector: . . . . . . . . . . 5-pin XLR
Dimensions (LxWxH):. . 185 x 90 x 63 mm
Weight: . . . . . . . . . . . . . 700 g
Receiver
.
Please save these instructions.
Transmitter
.
.