Battery Change; Technical Specifications - Antari M-30 Bedienungsanleitung

-Transmitter
With the transmitter it is possible to emit fog via radio over a distance of up to 50 meters. To
establish the signal transmission between the transmitter and the receiving unit, both must
be set to the same RF address [Radio Frequency address]. Nine RF addresses from 0 to 8
can be used. If several receiving units are set to the same RF address, they can be
controlled in parallel with a transmitter. Altogether, nine groups with an unlimited number of
machines can be operated in parallel via a single transmitter each.
-Setting the RF address
On the transmitter, the RF address is set via the DIP switches. For this purpose, screw off
the housing cover and set the respective switch to the lower position. An exception marks
RF address 0, here all switches must be set to the upper position.
O N D I P
Address 1:
Switch No.1 set to lower position
1 2 3 4 5 6 7 8
-Emitting fog
Slide the transmitter's clip upwards until it locks. Press the BLUE button, to emit fog. The
BLUE button has the same function as the button VOLUME on the receiving unit, i.e. the
fog output depends on the setting of menu item »Volume Out«. The display indicates
»Volume« followed by the defined value or »NON STOP BURST« when maximum fog
volume was selected. As additional control, the red LED lights. To stop the fog output,
press the RED button.

-Battery change

If the range of the transmitter decreases, the battery is probably exhausted and must be
replaced. For this purpose, screw off the housing cover and remove the used battery.
Insert a fresh 12 V battery type 23A as indicated in the battery compartment and refit the
housing cover.

-Technical Specifications

-Transmitter
Carrier frequency:. . . . . UHF 433.920 MHz
RF power output: . . . . . 10 mW
Range: . . . . . . . . . . . . . approx. 50 m
Battery: . . . . . . . . . . . . . 12 V, type 23A
Dimensions (LxWxH):. . 60 x 40 x 16 mm
Weight: . . . . . . . . . . . . . 30 g
-Receiving unit
Compatible with: . . . . . . M-5, M-10
Cable length: . . . . . . . . 2 m
Connector: . . . . . . . . . . 5-pin XLR
Dimensions (LxWxH):. . 185 x 90 x 63 mm
Weight: . . . . . . . . . . . . . 700 g
O N
1 2 3 4 5 6 7 8
Please save these instructions.
D I P
Address 0:
All switches set to upper position