Bosch BBQ Fan Originalbetriebsanleitung Seite 16

OBJ_BUCH-1771-001.book Page 16 Saturday, December 15, 2012 9:57 AM
16 | English
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
17.12.2012
Assembly
Attaching the Hand Strap (see figure A)
The hand strap 5 is used to secure the screwdriver with BBQ fan to your
wrist. This prevents the screwdriver with BBQ fan from accidentally falling
into the barbecue.
– Thread the thin end of the hand strap 5 through the eyelet of the screw-
driver.
– Guide the carrying strap through the thin loop and tighten the hand
strap.
Mounting the Nozzle (see figure B)
– Mount the nozzle 1 onto the BBQ fan 2.
The detent 6 must be heard to engage.
Mounting the BBQ Fan (see figures C–D)
– Before mounting the BBQ fan 2, the rubber cap 7 of the screwdriver
must be pulled off toward the front.
– Afterwards, mount the BBQ fan onto the screwdriver.
The BBQ fan must be heard to engage.
Dismounting (see figures F1
 Wear safety gloves and do not touch the hot nozzle. Danger of burn-
ing.
– Turn the release ring 3 in rotation direction  and pull off the BBQ fan
toward the front.
– Afterwards, mount the rubber cap 7 onto the screwdriver again.
Operation
Kindling/Lighting Up Charcoal Barbecues (see figure E)
The screwdriver with BBQ fan 2 may only be operated with mounted noz-
zle 1 and hand strap 5 (see "Assembly").
1 619 929 L81 | (15.12.12)
F2)
–
Bosch Power Tools