Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
FURYO II - Indoor Siren
I - Description
FURYO II is a self powered siren for indoor security applications producing a rated power of 100 dB.
This siren is tamprered when opening the cover and when removing the base from the wall.
The siren has the possibility of a built -in power back up, using a 9Vdc battery or a rechargable battery,
as to maintain a constant service in case of a failure of the main power supply.
II - Specifi cations
• Input power : 11 to 15 Vdc,
• Stand by current : 170 µA Maximum,
• Average alarm current : 130 mA at 13,8 Vdc.
• Back up power supply :
- Rechargeable battery 8,4Vdc / 120 mAh,
- Alkaline 9V battery / 550 mAh,
III - Installation and wiring
- The siren power supply must be protected by a 500 mA minimum fuse.
- When installing the siren over a distance of 50m or more from the alarm panel, it is recommended
to use a 2-pair (.6 mm dia.) conductor cable and doubling the pairs to supply enough power
to the siren.
- When using a back up alkaline battery, remove the jumper «STR1».
- Initial test is recommended using a battery, the panel being in alarm condition.
1. Enclosure opening
3. Wiring to the alarm control panel
• Wiring the siren with a battery back up
4. Tamper protection adjustment
Permanently in search of the highest quality,
Bosch Security Systems reserved the right to improve products and / or change specifi cations without notifi cation.
Copyright © 2009 Bosch Security Systems
FURYO II - 120FG005
• Output Power : 100 dB minimum at 1 m,
• Control voltage : + 12Vdc as blocking voltage,
• Applications : Alert device for indoor security systems,
• Temperature range : 0 °C to + 55 °C,
• Enclosure : 2-part ABS off white plastic esthetic box,
• Dimensions : 177 x 98 x 47 mm,
• Weight : 300g.
2. Installation of siren and battery
• Wiring the siren without battery back up
Installation Instructions FURYO II - F01U072546-05
Werbung
