Maintenance - EGO LB4800E Betriebsanleitung

Before each use, inspect the entire product for damaged,
missing, or loose parts, such as screws, nuts, bolts,
caps,etc. Tighten securely all fasteners and caps and
do not operate this product until all missing or damaged
parts are replaced.
APPLICATION
You may use this product for the purposes listed below:
◾
Clearing hard surfaces such as driveways and
walkways.
◾
Keeping decks and driveways free from leaves and
pine needles.
NOTICE:
The tool is to be used only for its prescribed
purpose. Any other use is deemed to be a case of misuse.
ASSEMBLING THE BLOWER TUBE (Fig. B & C)
◾
Align the tube grooves with the housing knobs and
push the tube forward until the knobs engage the
grooves.
◾
Turn the tube in the arrow direction until the knobs
slide into the lock positions.
INSTALLING/REMOVING THE BATTERY PACK (Fig. D)
Charge before first use.
WARNING:
Always remove battery pack from
the product when you are assembling parts, making
adjustments, cleaning, or when not in use. Removing
battery pack will prevent accidental starting that could
cause serious personal injury.
◾
To Install
Align the battery ribs with the mounting slots and press
the battery pack down until you hear a "click".
◾
To Remove
Depress the battery-release button and pull the battery
pack out.
WARNING:
Always take care of your feet, children,
or pets around you when pressing the battery release
button. Serious injury could result if the battery pack falls.
NEVER remove the battery pack when in a high location.
STARTING/STOPPING THE BLOWER (Fig. E)
◾
To Start
Press down the lock-off lever and hold it, then depress
the trigger. After a short delay, the blower will begin to
run.
◾
To Stop
Release the trigger.
ADJUSTING THE AIR VELOCITY
◾
To Increase/Reduce the Air Velocity
Turn the air velocity adjusting knob clockwise/counter-
clockwise to increase/reduce.
◾
To Enhance the Air Velocity
Press the boost button to achieve the maximum air speed.
NOTICE:
will resume the previous speed.
OPERATING THE BLOWER
◾
To keep from scattering debris, blow around the outer
edges of a debris pile. Never blow directly into the
center of a pile.
◾
To reduce sound levels, limit the number of pieces of
equipment used at any one time.
◾
Use rakes and brooms to loosen debris before blowing.
In dusty conditions, slightly dampen surfaces when
water is available.
◾
Conserve water by using power blowers instead
of hoses for many lawn and garden applications,
including areas such as gutters, screens, patios, grills,
porches, and gardens.
◾
Watch out for children, pets, open windows, or freshly
washed cars, and blow debris safely away.
◾
After using blowers or other equipment, clean up!
Dispose of debris properly.

MAINTENANCE

WARNING:
replacement parts. Use of any other parts may create a
hazard or cause product damage. To ensure safety and
reliability, all repairs should be performed by a qualified
service technician.
WARNING:
remove the battery pack from the product when cleaning
or performing any maintenance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
petroleum-based products, penetrating oils, etc., come in
contact with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal injury.
56 VOLT LITHIUM-ION CORDLESS BLOWER — LB4800E
Once the boost button is released, the blower
When servicing, use only identical
To avoid serious personal injury, always
Do not at any time let brake fluids, petrol,
EN
9