Technical Data; English | 13; Inserting And Removing The Battery - Bosch 1 270 020 900 Originalbetriebsanleitung

OBJ_BUCH-1397-001.book Page 13 Monday, January 17, 2011 3:11 PM

Technical Data

Drive Unit
Article number
Rated continuous
output
Output torque, max.
Rated voltage
Operating
temperature
Storage temperature
Degree of protection
Weight, approx.
Drive HMI
Article number
Operating
temperature
Storage temperature
Degree of protection
Weight, approx.
Lighting*
Rated voltage
Power output
– Front light
– Rear light
* Not possible via the eBike battery in all country-spe-
cific versions, depending on the statutory regulations
Bosch ebike Systems
Assembly

Inserting and Removing the Battery

Drive Unit
0 275 007 000/ For inserting and removing the battery in/from
0 275 007 001
the the eBike, please read and observe the bat-
tery operating instructions.
W 250
Inserting and Removing the Drive HMI
Nm 50
(see figure A)
V= 36
To insert the drive HMI, place it turned by ap-
prox. 30° onto holder 2 and then turn it clock-
°C –5...+40
wise to the stop.
°C –10...+50
To remove the drive HMI, turn it approx. 30° an-
ticlockwise and pull it out of the holder 2.
IP 5K4K (pro-
tected against
dust and
splash water)
kg 4
Checking the Speed Sensor
HMI
(see figure B)
1 270 020 900
The speed sensor 9 and its spoke magnet 10
must be mounted in such a manner that the
°C –5...+40
spoke magnet, after a turn of the wheel, moves
past the speed sensor with a clearance of no
°C –10...+50
more than 17 mm, max.
IP 5K4K (pro-
Note: If the clearance between speed sensor 9
tected against
and spoke magnet 10 is too large or if the speed
dust and
sensor 9 is not properly connected, the speed
splash water)
indication a will fail, and the eBike drive will op-
kg 0.15
erate in emergency mode.
In this case, loosen the screw of the spoke mag-
net 10 and fasten the spoke magnet to the
spoke in such a manner that it runs past the
V= 6
speed sensor with the lowest clearance possi-
ble. When the speed is still not being indicated
W 2.4
in the speed indication a after this, please refer
W 0.6
to an authorised bicycle dealer.
Remove the drive HMI when parking the
eBike, so that the drive cannot be used by
unauthorised persons. Without the drive
HMI, the drive cannot be switched on.
0 275 007 X00 | (17.1.11)

English | 13