Epomaker SPLIT70 Schnellstartanleitung Seite 3

FN + F7
Previous Track
FN + F8
Play/Pause
FN + F9
Next Track
FN + F10 Mute
FN + F11
Volume -
FN + F12 Volume +
LIGHT CONTOL
FN + X
FN + TAB
FN + \|
FN +↑
FN +↓
FN + ←
FN + →
FN + ;:
FN + '"
FN + [{
FN + ]}
ONE-CLICK FUNCTION
/
M1 CTRL+Z
/ CTRL+X
M2
/ CTRL+C
M3
/ CTRL+V
M4
F7
F8
F9
F10
F11
F12
Turn On/Off Backlight
Toggle Backlight Effects
Toggle Light Strip Effects
Backlight Brightness +
Backlight Brightness -
Backlight Speed -
Backlight Speed +
Backlight Saturation -
Backlight Saturation +
Backlight Hue -
Backlight Hue +
UNDO
CUT
COPY
PASTE
WIRED CONNECTION
1. Toggle the connectivity switch to the USB position, make sure the
keyboard is in the wired mode.
2. Plug in the USB-C cable to the Type-C port of the left half (between
the connectivity switch and 2.4G receiver).
3. When the backlight is on, the keyboard is connected.
PAIRING BLUETOOTH
1. Toggle the connectivity switch to the BT position, make sure the
keyboard is in wireless mode.
2. Hold and press FN+Q/W/E until the light indicator flashes quickly, the
keyboard is ready to pair.
3. Open up your Bluetooth device and find the name "Split70-1",
"Split70-2", or "Split70-3" and connect.
4. When the light indicator stop flashing and back to current backlight
effect, the keyboard is connected to your device.
*Note: Short press FN+Q/W/E to toggle among Bluetooth device 1/2/3.
CONNECT VIA 2.4G
1. Toggle the connectivity switch to the 2.4G position, make sure the
keyboard is in wireless mode.
2. The "R" key indicator flashes.
3. Insert the 2.4G receiver to your device.
4. When the "R" key indicator stop flashing and back to current backlight
effect, the keyboard is connected to your device.
*Note: Hold FN+R until the light indicator flashes quickly, the keyboard is in
the pairing mode.
EN