Manual Installation Wifi & Ethernet - Block Elements 5.1 Bedienungsanleitung

Manual Wifi installation
If any problem appears while setting up the assistant wizard, or you prefer to do a manual setup, please
proceed as follows:
Press the „Menu" button on the remote control. Using the arrows keys on the remote control, initially
choose „System Settings", then select „Internet Settings", „Manual Settings", and finally „Wireless" by
navigating there with the arrow keys on the remote.
Select „DHCP active" in the next step. This is the default setting of all conventional Internet router and it
skips a lengthy network configuration.* Confirm the setting.
Now enter the name of your wireless network (SSID), pay attention to the correct spelling and use of
capital/small letters. Confirm with "OK".
Select the type of your password protection (usually WPA2 and AES). In case of doubt, consult the manual
of your router.
Enter the password of your WLAN network, pay attention to the correct spelling and use of capital/small
letters. Confirm with "OK".
Now the router and your Elements 5.1 should be connected and an Internet connection should exist,
„Connected" shall appear on the display.
Manual Installation – Wired (Ethernet) Connection
If you prefer not to use a Wi-Fi connection and instead want to connect the Elements 5.1 to your router using a
cable (Ethernet), please follow these steps:
Connect a free Ethernet port on your router to the Ethernet port on the Elements 5.1 using an Ethernet
cable (RJ-45).
Press the „Menu" button on the remote control.
Then select System Settings -> Network -> Manual Settings and finally „Cable".
In the next step, choose „Enable DHCP".
This is the default setting for most standard internet routers and saves you from lengthy network configu-
ration.* Confirm the setting.
Your router and the Elements 5.1 should now be connected, and internet access should be available. The device
will display „Connected".
* Should you have disconnected the DHPC function on you router, select please "DHPC inactive". In this case, you must configure the Network, the rules
and specification should be known by now. For the configuration, you may need the MAC address of your Block device. You can find this under Menu/
System settings/Internet settings/Adjustment indicator/MAC address.
44