Bosch AXT Rapid 2200 Originalbetriebsanleitung Seite 16

OBJ_BUCH-2230-002.book Page 16 Friday, November 3, 2017 12:32 PM
16 | English
Overload Protection
Overloading (e. g. clogging up of the cutter) can lead to a
standstill of the machine after a few seconds. After a short pe-
riod, the machine can be switched on again.
If the shredder clogs up again, turn it off, pull out the mains
plug, and clear the blockage. Continuous overloading and
blocking up of the motor outlet vents can cause the motor
thermal overload cutout to trip. Clean the outlet mesh and
turn the shredder off for several minutes to allow it to cool.
The trip will reset automatically, but the shredder will not, of
course, start again until you turn the ON/OFF knob back to
"0" and repeat the start sequence.
Advice on Shredding
Branches become harder to shred depending on the type, age
and dryness of the wood.
Troubleshooting
The following chart lists problem symptoms, possible causes and corrective action, if your garden product does not operate
properly. If these do not identify and correct the problem, contact your service agent.
 Warning! Switch off, remove plug from mains before adjusting, cleaning or if cable is cut, damaged or entangled.
Problem Possible Cause
Machine fails to operate Switch fails to operate
Securing knob has not been fully tightened Tighten hopper securing knob
Power turned off
Mains socket faulty
Extension cable damaged
Fuse faulty/blown
Motor protector has activated
Power supply interrupted
On/Off switch returns to position "0"
Undervoltage protection
Machine functions Extension cable damaged
intermittently
Internal wiring of machine damaged
Motor protector has activated
On/Off switch returns to position "0"
Poor cutting performance Cutting blade blunt
Cutting blade dirty
Feed intake or discharge chute blocked
Cutting blade not rotating Cutting blade obstructed
Blade nut/bolt loose
Excessive vibrations/noise Blade nut/bolt loose
Cutting blade damaged
Machine damaged internally
F 016 L81 412 | (3.11.17)
For best results, shred fresh branches soon after they have
been cut.
Soft garden waste should be shredded in smaller loads, par-
ticularly when wet. Any blockages can be avoided by intermit-
tently shredding branches.
Blade Maintenance
 Stop and remove plug from the power supply.
The blade has a double-sided cutting edge.
When the cutting edges become blunt, the blade can be
turned over.
The blade bolt can be reused. Ensure it is tightened very firm-
ly when replacing the cutter disc. When both sides are blunt,
replace the blade. A new blade is available as a spare; use the
new bolt which is supplied with it.
Corrective Action
Do not push On/Off switch while it is being rotated
Turn power on
Use another socket
Inspect cable, replace if damaged
Replace/restart
Follow "Overload Protection" procedure
Follow "Overload Protection" procedure
Allow machine to cool then follow "Overload Protec-
tion" procedure
Restart machine. Check extension cable is as re-
quired in instructions (lower quality extension cable
can cause error). When powered by aggregator,
check its performance.
Check mains cable and have it replaced, if required
Contact Service Agent
Follow "Overload Protection" procedure
Allow machine to cool then follow "Overload Protec-
tion" procedure
Replace blade
Remove blade and clean
Clean machine and empty collecting bag
Clear obstruction
Tighten blade nut/bolt
Tighten blade nut/bolt
Replace blade
Contact Service Agent
Bosch Power Tools