Operation - SeaLand 8100 Series MasterFlush Bedienungsanleitung

Specifications
5.3 Dimensions
Standard-height models
Ref. Dimension
A
B
C
D
E
F
6

Operation

6.1 Toilet system start-up
1. Turn on water supply to toilet.
2. Press "Flush" switch (2) and hold for at least five seconds.
3. Toss several sheets of toilet paper into bowl and repeat
cycle. The bowl should completely clear.
6.2 Normal toilet operation
ADDING WATER TO TOILET BOWL
Press "Add Water" switch (1) and hold until desired water level
is achieved. (Do not press "Add Water" switch too long or
FLUSHING TOILET
Press "Flush" switch (2) down and hold for a few seconds after waste drains from toilet bowl (about
five seconds). This switch activates a powerful macerator pump that siphons water and waste from the
"DRY BOWL" OPERATION
During periods of rough travel, water in a toilet bowl can splash out and into the bathroom area. To
avoid this situation, press "Dry Bowl" switch (3) to drain water completely from toilet bowl. Water is not
added to bowl during or after pressing the "Dry Bowl" switch.
Caution – Do Not Flush Waste with "Dry Bowl" Switch!
To maintain proper cleanliness and operation of the toilet and macerator pump, water
6
3
(fig. , page 2)
Dometic 8100 Series MasterFlush Toilet
Low-profile models
Ref. Dimension
A
B
C
D
E
F
2
1
3