Kalor CPC160 Bedienungsanleitung Seite 556

Maintenance and cleaning / Boiler with cast iron brazier
All cleaning of all parts must be carried out with the Boiler completely cold and
unplugged to avoid burns and thermal shock. The boiler does not need much
maintenance if used with certifi ed quality pellet. The need for maintenance varies
depending on the conditions of use (switching on and off repeatedly) and depending
on the performance required.
check its condition.
Parts
Brazier
Cleaning the ash collection
compartment with suction device
Cleaning ash tray
Exchanger (turbulators)
Flame-shell
Cleaning the interior heat
exchanger /
smoke fan compartment
Cleaning complete exchanger
Clean "T" to exhaust
Flue
Door gasket ash
Internal parts
Flue pipe
Circulation pump
Heat exchanger (where present)
Hydraulic components
Electromechanical components
◊ by the user / • by the authorised qualifi ed technical assistance
BY THE USER
Daily control
The boiler requires a simple and thorough cleaning
in order to ensure a more effi cient performance
and smooth operation. Clean the grate using the
appropriate tool from the ash and any incrustation
which could obstruct the passage of air. In the case
of depletion of pellets in the tank may accumulate
unburned pellets in the burn pot. Always empty the
residuals from the grate before each start. Remember
that only a brazier located and clean properly can
ensure ignition and optimal operation of your boiler.
When positioning the crucible, carefully check that
the ends of the pads completely adhere to their
home and that the hole with pipe dedicated to the
passage of the resistance. There should be no residual
combustion in the contact zone between the edges
of the crucible and the support surface on the door
crucible.
40
It is recommended periodic monitoring of the boiler to
Every 2-3
Everyday
days
◊
◊
◊
◊
◊
Every Every 15 Every 30
week days days
Every 60- Every 1
90 days year
•
•
•
•
•
•
•
•
•
•
•