Trouble Shooting - Zipper Mowers ZI-RMR 1500 Betriebsanleitung

15

TROUBLE SHOOTING

BEFORE USING THE WORK FOR DISPOSAL OF DEFECTIVE START, DISCONNECT THE
MACHINE FROM THE POWER SUPPLY.
Trouble
After turn on the mower by key
and set operate pattern, but the
mower still cannot start. In
addition, the charging station is
beeping.
After turn on the mower by key
and set operate pattern, but the
mower still cannot start
Mower stop working and is start
to beeping.
The robot is very noisy
Mower does not detect the
charging station contacts
Mower reached the charging
station when its contacts are
above the charging station
contacts
Mower drives but blade will not
mow
Remote control does not work
Unknown trouble
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
RASENMÄHER-ROBOTER / ROBOT LAWN MOWER ZI-RMR
Possible Cause
 The virtual wire fails to send
signals.
 The virtual wire is broken
 No power to plug receptacle or
main power is shut off. Bad
communication between
charging station and mower
• Mower is lifted over 2cm from
the ground.
• Cutting height too low.
• Blade or running wheels strike
hard objects.
• The mower is trapped in lawn.
• Mower is tilted over than 30
degree from the ground
• Bump sensor is activated
• Damaged cutting blades
• Cutting blade flooded by
residues(tapes, ropes, plastic
fragments, etc.)
• The ground before the charging
station is not flat.
• Height difference between the
charging station and the lawn
surface at the entrance to the
charging station.
• On manual pattern, Mow on
remote control has be turned
off.
• The electricity power is low
• Unknown
1500e 50
TROUBLE SHOOTING
Solution
 Check the virtual wire light
(colourless). Be sure the virtual
wire is connected to the
charging station that is motion,
and there is no loose place.
 Connect the wire with virtual
wire connectors
• Check the power and check the
plug. Connect charging station
with power supplier
• Put the mower in lever ground,
turn off the mower and restart
it.
• Adjust the cutting height to
suitable height.
• Clean the grass and make sure
it is free from hard objects.
• Clear the lawn where the
mower is trapped or restart the
mower in another place.
• Put the mower in lever ground,
turn off the mower and restart
it by enter password and choose
operate pattern
• Free bump sensors
• Replace the blade with a new
one.
• Stop the robot in safety
conditions; remove the fold
cause from the blade.
• Reset the charging station in a
flat place
• Confirm the ground before the
charging station is leveled with
the charging station if
necessary fill area with dirt and
level off.
• Turn on the mower button
• Change batteries
• Turn off all switches and restart
the mower
Seite 50