cecotec BOLERO DRESSCODE DRY 3150V Bedienungsanleitung Seite 120

ENGLISH
1. Insert your fingers into the 4 openings around the centre of the filter cover and remove it.
2. Remove the filter assembly.
3. Cleaning:
Filter: use a soft brush or water to remove dirt.
o
o Rear filter: after removal, use a soft brush to remove lint, or use a vacuum cleaner or
water to remove dirt.
Note: the rear filter washed with water may wrinkle.
4. Reinstallation:
Reassemble in this order, aligning with the central shaft: cotton filter – filter – filter cover.
Make sure that the centre concave part of the filter cover and the centre convex part of the
filter fit correctly.
The front cotton filter should be cleaned at least once a month. Fig. 4
1. Grasp the lower end of the front filter screen with some force, push it up and pull it out.
2. Remove the cotton filter from the front filter, remove dirt with a vacuum cleaner or with
water; ensure the filter is completely dry and reinstall it in the tumble dryer.
Make sure the cotton filter is clean so that the dryer operates normally and improves drying
efficiency.
6. TROUBLESHOOTING
Some failures are due to lack of simple maintenance or inspection and can be resolved without
technical personnel. Please read the following malfunctions and solutions carefully before
contacting Cecotec's Official Technical Support Service.
Errors
The knob does not
work.
The drum does not
rotate.
No hot air comes out.
120 BOLERO DRESSCODE DRY 3150V
BOLERO DRESSCODE DRY 3150V DARK
Possible causes
The dryer is not connected to
the power socket.
There is no power in the
socket.
The dryer is not connected to
the power socket.
The door is open.
The knob is in the cold air
position.
Solutions
Connect the dryer to the power
supply.
Check the socket.
Connect the dryer to the power
supply.
Close the door.
Turn the knob to the hot air
position.