Herunterladen Diese Seite drucken
Verfügbare Sprachen

Verfügbare Sprachen

USER MANUAL
You have just purchased an PG Ceiling Fly killer and we hope that it will give complete satisfaction.
This device is specially designed to fit into the place of a 60x60cm suspended standard ceiling tile.
POSITIONING
Your unit should ideally be fixed preferably in the
darkest place within the area to be protected,
away from windows and skylights, thus avoiding
any competition with natural daylight
sunlight.
In large open areas where two or more units are
required, siting needs careful consideration to
ensure maximum protection. Each unit within a
certain area should be centrally positioned.
The positioning of the units varies depending on
the location. Should any queries arise on sitting
please contact your supplier.
POWER REQUIREMENTS
The units are designed to operate from the
following power supply: 220/240V – 50/60Hz
Therefore, please ensure that your unit is
compatible with the electricity supply in your
premises.
SERVICING
Before any form of servicing, ensure that the unit
is disconnected from the mains supply.
To maintain the units efficiency, replace the UV
fluorescent bulbs every 12 months ( the UV LED –
24 months), glue boards must be replaced every
2 months.
If any doubts arise regarding these instructions,
please contact your supplier.
Model
PG40LB
PG10LB
BRC PG40LB / PG10LB / 85437090
Ceiling Fly killer
Power Supply
230V – 50 Hz
230V – 50 Hz
WARNING
The units must only be used in areas
which are free of dust and possible
explosive vapour mixture. Should
you have any queries contact your
or
local fire authority for advice before installation.
The units are only suitable for indoor use and is
not suitable for use in barns, stables and similar
locations.
IMPORTANT
This appliance can be used by children older
than 8 years and by persons with diminished
physical, sensory or mental capacities or no
experience, only if they are correctly supervised
or if they have been given the instructions on
how to use the appliance with complete safety
and if they understand the risks involved.
Children mustn't play with this device. This
device must be placed out of touching from
children (seen "POSITIONING") Cleaning and
servicing mustn't be made by user without
knowledge of the specific processes (A2 / EN
60335-1).
GUARANTEE
Your unit is guaranteed for 5 years (excluding
replacement bulbs and glueboards). If a fault
occurs, contact your supplier, who will replace
your unit providing the product has been
operated under normal conditions.
UV Light
Protection area
2x20W (E14)
2x 5 W (E14 LED)
Dimensions
100 m²
595 x 595 x 80mm
100 m²
595 x 595 x 80mm
17/04/2023
Indice D
Page 1/10
loading

Inhaltszusammenfassung für BRC PG40LB

  • Seite 1 230V – 50 Hz 2x20W (E14) 100 m² 595 x 595 x 80mm PG10LB 230V – 50 Hz 2x 5 W (E14 LED) 100 m² 595 x 595 x 80mm Indice D 17/04/2023 Page 1/10 BRC PG40LB / PG10LB / 85437090...
  • Seite 2 été utilisé dans les instructions, contactez votre fournisseur. conditions normales. Modèle Alimentation lampe UV Zone de couverture Dimensions PG40LB 230V – 50 Hz 2x20W (E14) 100m m² 595 x 595 x 80mm PG10LB 230V – 50 Hz 2x 5 W (E14 LED) 100 m²...
  • Seite 3 Superficie de Modelo Alimentación Potencia Dimensiones protección PG40LB 230V – 50 Hz 2x20W (E14) 100m m² 595 x 595 x 80mm PG10LB 230V – 50 Hz 2x 5 W (E14 LED) 100 m²...
  • Seite 4 220~240V – 50~60 Hz und muss zwingend geerdet werden. Modell Stromversorgung UV Leuchtstoffröhren Anwendungsfläche Größe 595 x 595 x PG40LB 230V – 50 Hz 2x20W (E14) 100m m² 80mm 595 x 595 x PG10LB 230V – 50 Hz 2x 5 W (E14 LED) 100 m²...
  • Seite 5 INSTALLATION Secure the device (earthquake protection) Indice D 17.04.2023 Page 5/10...
  • Seite 6 INSTALLATION Connect the device and Secure the electrical line: A -Insert the cable retention Accessory B - Insert the supplied collar C - Insert the cable in the connector following the instructions beneath Alimentation cables must be 1,5mm² wide COMPULSORY EARTHING Indice D 17.04.2023 Page 6/10...
  • Seite 7 D -Tighten the cable with the supplied collar Mount the device in the suspended ceiling ! WARNING ! No insulation above the device !!! Indice D 17.04.2023 Page 7/10...
  • Seite 8 SERVICING IMPORTANT : Before any servicing, Put the device offline by switching the line Breaker OFF Open the device and take out the glueboard support Replace light bulbs and glueboard with standard BRC ones Indice D 17.04.2023 Page 8/10...
  • Seite 9 PIECES DETACHEES - SPARE PARTS – ERSATZTEILE - PIEZAS DE REPUESTO Indice D BRC SAS – 21 rue des coteaux de Grand Lieux – 44830 BOUAYE 17.04.2023 info@brcsa.com - Tel. 02 40 34 57 24 – Fax. 02 40 34 74 76 – www.brcsa.com...
  • Seite 10 BRC SAS 21 rue des coteaux de Grand Lieux 44830 BOUAYE – France info@brcsa.com Tel. 02 40 34 57 24 – Fax. 02 40 34 74 76 www.brcsa.com Indice D 17.04.2023 Page 10/10...

Diese Anleitung auch für:

Pg10lb85437090