Touch Screen Cleaning; Filter Cleaning - Nordcap Nc81N Benutzerhandbuch

Maintenance

Touch screen cleaning

Use a cloth just soaked in a specifi c product for the crystals fol-
lowing the instructions of the manufacturer of the detergent.
Do not spray too much product to avoid infi ltrations that could
damage the display.
Slot and grill/sponge cleaning
Keep vents free of obstructions and dust cleaning them often with
a normal vacuum or brush.
Periodically it is recommended to lift the front panel by remov-
ing the screws below and vacuum the dust accumulated on the
condenser fan. Lifting the panel also gives access to the conden-
sation water collection tray between the condenser and the com-
pressor.Inside it, there is a "GM" metal grill that acts as a sponge
and absorbs water, increases the exchange surface and facilitates
the evaporation of condensation water; this "grill/sponge" must
be regularly removed and cleaned with soap and water or in the
dishwasher.

Filter cleaning

On the right side of the condenser there is a "FL" fi lter held in place
by two metal clips. Periodically remove it and wash it with soap
and water. After waiting for it to dry completely, put it back in
place. Do not use the machine without a fi lter.
Disuse
During periods of inactivity, disconnect the power and water
supply (if any). Protect external steel equipment parts wiping
them down with a soft cloth slightly dampened with Vaseline oil.
Leave the door ajar to guarantee correct ventilation.
Before resuming operations:
- accurately clean the equipment and accessories;
- reconnect the equipment to the power and water mains (if
any);
- inspect the equipment before using it;
- restart the equipment for at least 60 minutes without any food
inside.
To ensure that the device is in perfect use and
safety conditions, we recommend you have it
maintained and serviced by an authorised ser-
vice centre at least once a year.
3
2
Attention,
dashboard
not stay up on its
own!
38
H O
H O
2
2
GM
x3
the
does
rev. 0 - 02/2019
F
1