Interline Filterset Pro Bedienungsanleitung Seite 10

» The filter system is now vented. lf applicable, open the vent screw
on the upper side of the transparent filter cover until the water flows
out.
» Release the shut off valve at the intake port (Skimmer) in the pool.
lf you plugged the intake port (Skimmer), remove the plug to allow
the water to flow into the intake hose.
» With the filter-pump system installed in a location level lower than
your pool's water level - water will automatically flow into the
pump-filter system.
» Allow the filter tank to fill with water.
» Check the filter system and the connection hoses for leaks and
resolve, if necessary. Leakage points may possibly arise due to
manufacturing tolerances, which need to be resolved by wrapping
teflon tape around the connections before the connection hose is
attached.
» Your filter system is now ready for use.
11.1 Cleaning filter balls
The filter balls in the filter tank ensure that dirt particles and floating
debris are effectively filtered over a long period of time.
The filter system will reduce its level of performance in accordance
with the amount of contamination in the water. This must be
checked at regular intervals.
lf you establish that performance levels are decreasing, please follow
one of these two options:
A: Replace the filter balls.
B: Wash the filter balls in a washing machine at a maximum
temperature of 30°C.
11.2 Filtering time
The water in the pool should be circulated and filtered at least 3 to
5 times in a 24 hour period, depending on the load and the size of
the filter system. The time required is based on the performance of
the filter system and the size of the swimming pool. However, we
recommend a minimum running time of 12 hours per day.
11.3 IMPORTANT NOTE
11.3.1 Care instructions
Visible contaminants are removed through the filtration system.
This is not true for algae, bacteria and other micro-organisms, which
are also a constant threat to clear, clean and healthy pool water. For
Their prevention or removal, special water treatment is available,
properly and permanently dosed, guarantee for swimmers any kind
of harassment and ensure proper hygienic bath water.
11.3.2 Cleaning
Use conventional cleaning products. Do not use solvent-based or
abrasive cleaning agents/tools, i.e. no hard sponges, brushes etc..
11.3.3 Storage
The product must be thoroughly dried after cleaning. After which, it
is to be stored in a dry location protected from frost.
11.3.4 Disposal
Disposing of packaging: The packaging material has been selected
in view of environmental concerns and disposability and is therefore
recyclable.
10
The paper and cardboard can be recycled, as can the plastic
coverings. Disposing of the product: Applicable in the European
Union and other European states with systems in place for col-
lecting and sorting recyclable materials. Dispose of the product
in accordance with any laws and regulations applicable at your
place of residence.
11.3.5 Warranty conditions
Two years warranty after the date of invoice.
12 TROUBLESHOOTING
Cause Solution
Dirty Sand Carry out a Counterwash (Wash the
sand)
The pump sucks The hosepipe could be detective.
air (bubbles in the Tighten the clips
aspiration)
The water level of the Check the level and raise it if
skimmer is low. necessary.
The skimmer basket Clean the basket and replace it
has moved. correctly.
The basket of the Clean the pre-filter basket and
pump pre-filter has replace it.
moved.
In case of finding problems not mentioned above, please consult
your usual salesperson.
EN