Additional Notes For The Signolux Module - HumanTechnik signolux Guardion Bedienungsanleitung

13. Notes for the signolux transmission module
Function
In case of fire, the »signolux smoke detector« transmits a wireless fire
alarm signal to all paired signolux-receivers within range.
EN
Registering the smoke detector with the receivers
The »signolux smoke detector« has to be registered with every
signolux-receiver in your system, which is later supposed to react to it.
Registering the detector with a receiver allows the choice of indicati-
on on the according receiver. To register the detector with the relevant
receiver, press and hold that receiver's function key. The receiver's
event symbols light up in sequence. Release the function key as soon
as the required alarm symbol » « or » « is lit up.
The selected symbol lights up for 7 seconds. While the symbol is lit,
press the test button on the module inside the detector. The exterior
test button on the outside of the smoke detector can also be used,
but please note that this will also trigger the detector's acoustic
alarm.
Wait for approx. 20 seconds and the test the setup by pressing the
47