Hensel RF 3000P-XS Benutzerhandbuch Seite 20

User manual // Ring flash RF 3000P/PM-XS and 3000-XS
20
 Do not route cables across the studio floor if possible,
so that damage is excluded. If routing across the
studio floor cannot be omitted, then it must be ensured
that vehicles, ladders, etc do not damage cables.
Damaged cables and cases must be replaced
immediately by customer service.
 Flash systems must not be used in environments with
explosion hazard. Flammable materials, like furnishing
fabrics, paper, etc. must not be stored in the immediate
vicinity of flash heads to prevent fire hazards.
 Ring flashes must be protected against humidity and
spray water.
 Do not connect accessories from other manufacturers,
even if they use the same or similar connectors.
 Do not flash into eyes at short distances (smaller than
5 m), because this can lead to eye damage. Do not
look directly into the flash reflector, the flash lamp
could be triggered inadvertently.
 Regularly air closed rooms to prevent build-up of
inadmissible ozone concentrations, which can occur
due to the use of high-powered flash systems.
 During work in the studio generating much dust, the
appliance must be covered with suitable dust pro-
tection (not during operation).
HENSEL-VISIT GmbH & Co. KG