Inhaltsverzeichnis
Werbung
36
W/WD drives
Setting the SCSI ID jumpers
Use the J6 jumper block to set the SCSI ID (Figure 9). To change
the SCSI ID, install jumpers on the appropriate pins as shown in
the illustration. Optional connections to switching circuits in host
equipment are provided on J1 auxiliary to set the SCSI ID (see
Figure 10).
Figure 9.
Setting the SCSI ID
Barracuda 9 Installation Guide, Rev. B
W/WD drives section
Drive
Front
Jumper Plug
(enlarged to
show detail)
Reserved
SCSI ID = 0
(default)
SCSI ID = 1
SCSI ID = 2
SCSI ID = 3
SCSI ID = 4
SCSI ID = 5
SCSI ID = 6
SCSI ID = 7
SCSI ID = 8
SCSI ID = 9
SCSI ID = 10
SCSI ID = 11
SCSI ID = 12
SCSI ID = 13
SCSI ID = 14
SCSI ID = 15
Pin 1
J6
L
R
E
E
A 3
A 2
A 1 A 0
D
S
Werbung
Inhaltsverzeichnis
