Inhaltsverzeichnis
Werbung
20
Initial setup information
The general information beginning on this page applies to all of
the Barracuda 9 drive models. After reading the general informa-
tion topics, refer to the appropriate drive-specific section listed
below for additional information about configuring and installing
your particular model.
Drive models
ST19171N
ST19171W
ST19171WC
General information
The following general information topics are discussed:
• SCSI ID jumpers
• Drive termination
• Terminator power
• Interface drivers and data path width notes
• Other applicable jumper options
• Providing adequate cooling
• Mounting the drive and connecting cables*
• Formatting the drive
*This mounting procedure does not apply to WC or DC model
drives. To mount a WC or DC drive, plug the drive into the sys-
tem's single connector attachment (SCA) position on the sys-
tem's back panel.
Barracuda 9 Installation Guide, Rev. B
ST19171WD
ST19171DC
Page
32
36
41
Werbung
Inhaltsverzeichnis
