Functional Description 61034; Functional Description 61334 - Audiotechnik Dietz 61034 Bedienungsanleitung

Functional description 61034

The following signals can be read out of the CAN data bus with this cable kit:
- Ignition (Terminal 15, 1A maximum load!)
- Illumination (Terminal. 58, 1A maximum load!)
- Speed impulse: square wave signal, 0,64 Hz per km/h
- Signal for reverse gear (depends on cars' configuration)
- Steering wheel remote control for BECKER (if exists)
For a complete List of compatible head units, please refer to the installation manual of the specific
CAN interface.
Assignment of the ISO power connector from the cable kit:
The blue mini ISO jack from the cable kit serves as connection of the steering wheel remote
control. It has to be plugged into the upper right chamber of the terminal block.
The function table for the steering wheel remote control can be found in the appendix.
_______________________________________________________________________________________________

Functional description 61334

The following signals can be read out of the CAN data bus with this cable kit:
- Ignition (terminal 15, 1A maximum load!)
- Illumination (terminal. 58, 1A maximum load!)
- Speed impulse: square wave signal, 0,64 Hz per km/h
- Reverse gear (depends on cars' configuration)
- Steering wheel remote control (if exists) for units from different manufacturers
The blue 18pin AMP plug from the cable kit serves as connection for the steering wheel remote
control using additional adapters. The part no.'s of those adapters as well as compatible head
units can be found in the installation manual of the specific CAN interface.
Assignment of the ISO power connector from the cable kit:
1: speed 3: tel. mute
2: reverse 4: memory
4: memory
® ®
Copyright © by Audiotechnik Dietz Vertriebs-GmbH ● Germany
Rev 4, Stand: 04/2008
5: Remote 7: ignition
6: illumination 8: ground
5: Remote 7: ignition
6: illumination 8: ground
13
E
N
G
L
I
S
H