Blue Eco Titanium 240 Gebrauchsanleitung Seite 3

6. Press 'SELECT' again to move to the next digit and do the same thing. You can change all four digits in this way. If you make a
mistake, you can press the 'SELECT' button until the corresponding number flashes again so you can change it.
7. Check carefully that the four digits match the code you received, and then press 'ENTER'.
8. The display now shows 'ALERT KEYDATA MODIFIED'.
9. Now press 'RESET'; code 1 is saved.
10. Wait until '0' appears on the display and repeat steps 2 to 9 to enter code 2, but in step 3 you must press the  button six times to
reach code 2.
Once the display shows '0' again, you can press 'RUN' to start the pump. You can use the  and  buttons to change the speed. If you
are unsuccessful, contact the Blue Eco service helpdesk on 0031-413-747009 or at blue-eco@sibo.nl.
If you registered your pump on the website it is not necessary to send in the supplied warranty papers. Keep them safe for future use.