CASO DESIGN HD1000 Bedienungsanleitung Seite 29

2. Place your cup on the removable drip tray, make sure
it aligns with the spout.
3. You can select the drip tray A/ B attachment (2) for
various cup sizes.
4. First press about 3-5 seconds.
up.
5. Press to choose your desired temperature and
press to set the water volume.
6. Press to operate the appliance. After 5-10 s, the desired water will flow out
continuously from water spout. Press
obtained. The appliance will stop working at once.
If you want to obtain water again, repeat the steps above.
7.
► If device was not used for longer time there could be scale deposits despite water filter. In
this case let 100 ml with 100 °C run through the device.
► The appliance has a memory function if the plug is still plugged in. The settings, that were
adjusted the last time, are still adjusted. The settings will be reset after unplugging.
► The ambient temperature changes everyday. This leads to different amounts of water. It
can vary up to +- 15%.
3. Water disposal from the drip tray
1. When the drip tray is full, grasp and stabilize the
appliance by one hand and use the other hand to lift up
the drip tray slightly to remove it.
2. Empty the water tray and insert it into the original place.
Make sure it is properly inserted.
4. Replacing the filter
1. Open the tank cover and take out the box with the filter.
2. Soak the filter upright in water for 10 min.
3. Rinse the filter under running water for 10 sec.
4. Remove the old filter and replace it with a new filter (see fig.). Therefor take out the
filter box, place the new filter and pull it down from the bottom.
Caso Heißwasserbereiter HD1000
Please note
and light
again, when your desired amount of water is
29