Flysurfer Strider Handbuch Seite 5

All set - let's go!
1. Unpack
Open the bag and remove the tightly packed-
together board as well as the accessories.
2. Setup
Attach the pump hose to the pump by
turning clockwise.
Mount the three fins, pay attention to use
the correct mounting direction.
To let the fins hook in more easily,
!
apply light up wards pressure from
underneath the fin position.
Remove the compression band.
Roll and spread out the board with the top
facing upwards.
Make sure to check that the valve on the tail
of the board is closed, the yellow valve head
should be at the same height as the grey ring.
If it is not closed, push the check valve in and
turn it clockwise 90 degrees.
Stick the end-support of the pump hose into
the check valve and turn the end-support
clockwise.
ENGLISH