HERA DynamicController Montage- Und Betriebsanleitung Seite 6

Assembly and operating Instructions
Hera WiFi Light Control System
Type 24V WiFi Controller 2 Dynamic
Remote-Function - Controls via Internet
The remote function is activated by default, this can be checked via the
following steps
1. Tap the cogwheel symbol at the top left and select the
device settings
2. If both symbols are blue, the remote function is already activated.
3. If the Internet symbol is greyed out, tapping on the device opens the
menu for the remote control
4. Activate Remote Status
Reproduction of this document in whole or part is forbidden.
24 V DC max. 75W
Hera GmbH & Co. KG
®
Dieselstraße 9
32130 Enger / Germany
Assembly and operating Instructions
Hera WiFi Light Control System
Type 24V WiFi Controller 2 Dynamic
Reset
The following switching sequence describes the reset to factory settings. After reset to factory settings the WiFi
Controller is switched to the Stand-Alone-Mode.
On
3 sec
Off
3 sec
alternative
With a needle or paper clip press and hold the button
„RST".
• long pressure (8 seconds):
The factory settings of the WiFi Controller are
restored. The WiFi Controller is switched from
network mode to Stand-Alone-Mode.
Frequently Questions
In „Stand-Alone-Mode" only 1 WiFi Controller can be connected to a smartphone. In network mode the quan-
tity that how many WiFi Controller can be connected depends on router level.
When failed to connect smartphone and WiFi Controller follow these conditions:
• Check power supply
• Check if smartphone can be connected to WiFi network normally
• Check whether Controller is connected to W-LAN successfully or not. If not search W-LAN with smartpho-
ne and connect LEDnetxxxxxxxxxx
• Run App and make sure it shows the WiFi Controller.
• Network mode:
• Check status of network in Settings. If status is „unconnected" check password of the router.
• If password is wrong reconnect the router to the smartphone.
• If the passwort is right but the network is still unconnected power off WiFi Controller for 3 seconds.
Wait additional 3 minutes and check status of network by same methods.
• If the network is still unconnected power off router and WiFi Controller. Wait a couple of minutes
and restart router and WiFi Controller.
Declaration of Conformity:
Hera GmbH & Co. KG declares that the product „ Hera 24V WiFi Controller 2 Dynamic " corresponds to the
directive 2014/53/EU. The full text of the EU-Declaration of Conformity is available on the following internet
address:
http://www.hera-online.de/en/technical-information/declaration-of-conformity.html
Only clean surfaces with a mild
cleaning agent using a soft cloth!
Reproduction of this document in whole or part is forbidden.
24 V DC max. 75W
Connected
luminaires are
flickering. Reset
finished
8 sec
needle
Do not dispose of electrical appliances in household waste, use separate
collection facilities. When replacing old appliances with new ones, the
retailer is obliged by law to accept to take back your old appliance for
disposal free of charge.
Hera GmbH & Co. KG
®
Dieselstraße 9
32130 Enger / Germany