Software Installation; Usb Driver - Brunner Cls-B Rudder Schnellstartanleitung

3 SOFTWARE INSTALLATION

5

USB DRIVER

USB Driver is installed automatically when power is applied the first time.
Rudder must show up in Windows as Game Controller «CLS-B Rudder» (standalone mode).
Run any flight simulator program and map the z-axis to yaw.
Optionally assign x-rotation axis to left brake and y-rotation axis to right brake.
CLS2SIM (V 5.3 or later)
For enabling additional Control Loading Features download CLS2Sim (Win32 application)
from https://helpdesk.brunner-innovation.ch/download/
If the optional CLS2Sim Software is installed, all axes are mapped by the software automati-
cally.
IN THE CASE THAT CLS2SIM IS USED, THE USB YAW AND BRAKES MAPPING
FOR THE CLS-B RUDDER MUST BE DISABLED IN THE SIMULATION SOFTWARE.
DUAL RUDDER SETUP / SYNCHRONIZATION
In case of 2 CLS-B RUDDER (MCC Configuration) connect a standard
RJ45 Cat5 Ethernet cable on the "CANopen" connector between the
units (See Chapter 5 Wiring Diagram on page 27).
All necessary settings for self-synchronization is done automatically at
the first power up of the devices.
Read the manual and help file in CLS2Sim (F1) for additional informa-
tion. In case of questions or troubles file a Ticket in our Helpdesk or
contact support@brunner-innovation.swiss.