Installation Instructions; First Start - Brunner Cls-B Rudder Schnellstartanleitung

2 INSTALLATION INSTRUCTIONS

GENERAL
Open the box carefully and remove all packaging.
The following material is included:
1. CLS-B RUDDER
2. USB Cable
3. Power supply with cable
4. Hex bit screwdriver (5mm) for pedal plate angle setting
5. This manual
MOUNTING & OPERATING CONDITION
1. The unit must be mounted with 4 Screws (not included)
securely on a flat surface before operating.
2. Keep a minimum of 5 cm distance around the unit from
any part.
3. Keep environmental temperature below 40°C max.
Use only in dry environment.

FIRST START

1. Connect the provided power supply to Power Plug.
2. Connect the CLS-B RUDDER with your computer via
the provided USB cable.
SEE CHAPTER 5 WIRING DIAGRAM ON PAGE 27.
3. Connect the AC main power Plug. The calibration and
initialization sequence will start automatically.
DO NOT DISTURB THIS SEQUENZ UNTIL THE YOKE IS
CENTERED! THIS SEQUENCE IS REPEATED EVERY TIME
WHEN POWER IS APPLIED.
4