Concept2 RK4070 Handbuch Seite 25

PRODUCT DESCRIPTION
1. Lid
2. Kettle body
3. Water mark
4. Handle
5. Switch
6. Supply cable base
C AUTION
Prior to first use, we recommend boiling the maximum volume of water in the kettle at least 3 times, then
pouring it out. The kettle is then ready for operation.
The kettle may only be used with the supplied base.
OPERATING INSTRUCTIONS
1. Remove the kettle from the base (6), open the lid (1), and fill the appliance with cold water within the
permitted maximum only. If the water level in the kettle is under the recommended minimum, the
kettle will keep overheating and turning off prematurely.
Note: Make sure that the lid (1) is closed properly, otherwise the kettle
can not turn off automatically
2. Place the kettle on the base (6); electric contacts will get connected
automatically. Thanks to the central connector design, the kettle can turn
around 360° and be put on the base from any side.
3. Connect the base to the mains.
4. Turn the kettle on by pressing the switch (5).
A control light on the switch (5) signals the kettle is in operation. The
kettle lid (1) must be properly closed when water is being heated.
WARNING!
Do not open the lid during heating or immediately after heating is
completed. Hot steam could scald you!
5. After the boiling point has been reached, the kettle will turn off
automatically, and the operating light will go out. Water heating can be
terminated prematurely by moving the switch (5) to the off position.
6. Remove the kettle from the base (6) and use the hot water.
7. If you want to reheat the water you have just finished boiling, wait for approximately 30 seconds
before reactivating the switch (5).
RK 40 7 0
1
1
3
2
2
7
6
EN
6
5
3
4
5
8
Obr. 1
Fig. 1
25