System Remote Control - Grundig Fine Arts M 100-T Servicehandbuch

Allgemeiner Teil / General Section
1 2 3 4 5
6 7 8 9 0
AV
P
P
P
P
P
P
REAR SURROUND CENTRE
+
– Install
$ #
STATION
RECORD
HIFI TV/VCR
VOLUME
Programme type (PTY)
RDS allows you to select FM stations according
to programme type. More and more stations are
codifying their programme type allowing efficient
search with the PTY function. The transmitted code
is however, the responsibility of the radio station.
There are 6 programme categories.
• Press TUNER/pty
– The display shows the actual programme type.
• By pressing within 2 seconds the $ STATION #
buttons, you can call up the programme types
one after another.
– After 2 seconds the unit starts scanning the
memorized stations to find a station
broadcasting the required programme type.
As soon as such a station is found it is tuned
to.
– If there are no stations broadcasting a given
programme type, the display briefly shows:
'NONE'.
What is meant by programme types?
NEWS = news service, politics and current
events, special informative reports
SPORT = sports
CULTURE = learning and continuation of
education, radio plays, literature,
culture, church and society, science,
light entertainment programmes
POP = pop music, rock music
CLASSIC = light and serious classical music
OTHER =
easy music, programmes that cannot
be assigned to one of the above
mentioned programme types.
1 - 10

SYSTEM REMOTE CONTROL

1 2 3 4 5
8
6 7 9 0
$ #
STATION
MUTING STEREO
MUTING STEREO
MUTING STEREO
SYSTEM REMOTE CONTROL
This remote control is supplied with the
amplifier M100 A or M100 ADPL.
The following radio functions can be carried
out with the remote control:
Selecting the TUNER:
• Press the TUNER/pty button.
Selecting stations:
• Press the $ STATION # buttons to call up the
stored memory locations one after another.
Empty locations will be skipped.
• You can also directly select the memorized
stations with the numeric buttons 1...0:
• For one-place memory location numbers,
ANTENNA
press the corresponding button only briefly.
• For two-place number, first press the first
MHz
number longer until this number jumps to the
left side of the display: 4-.
• Then enter the second number.
– If you have selected a memory location to
which no station has been assigned (yet),
'FREE' appears briefly in the display.
ANTENNA
The unit then switches to the most previously
set memory location.
MHz
Changing display indication:
• Pressing TXT/ briefly switches the display
mode between (when available) station name
(RDS or one you have entered), RDS-TIME,
RADIOTEXT (with RDS stations), and frequency.
– When the station name is displayed, only the
memory location number is displayed to the left
of the name.
ANTENNA
MHz
Assigning station names:
Stations which do not transmit the RDS code can
be assigned any name of your choice.
• Press TXT/ on the remote control longer than
1 second
• With Q or R , you can move the cursor
in the desired direction. You can enter up to
eight characters.
• With $ STATION #, you can move forward
and backward through the alphabet, the
numbers 0-9 and to the space key.
• When you are ready to conclude an input
and exit the input mode to store a name,
press TXT/ again.
Note:
If you attempt to assign a name to a station
which transmits the RDS code, RDS-DATA
appears in the display, indicating that a name
cannot be assigned.
Deleting a name
• If you press CANCEL when the input mode is
selected, the previous name is deleted and the
cursor jumps to the first (left) position.
M 100-T
GRUNDIG Service