Clip At The Analogue Exchange - Agfeo Al-Module 4504 Installationsanleitung

English

CLIP at the Analogue Exchange

In default the PABX is set that an incoming call will ring an extension without using the CLIP
function. However, you may enable this function by changing the setting in 'Wait for CLIP'.
The forwarding of the CLIP information from the telephone network may take up to 5
seconds, during this time the system will be idle. Therefore the extensions will ring with a
delay of up to 6 seconds. It may be useful to make use of the function 'Wait for CLIP' if this
information will not be displayed at your extension, or if you use a call filter or SMS
messaging via the analogue line.
Wait for CLIP (Firmware 6.x)
Enter programming mode:
*73855
Wait for CLIP procedure
Exit programming mode:
Wait for CLIP (Firmware 7.x)
Enter programming mode:
*73855
Wait for CLIP procedure
Exit programming mode:
*705
z
two-figure exchange
(01-last exchange)
*700
*705
z
enter external telephone number
*700
z
1=on
0=off
#z
1=on
0=off
11