DEFA homeCLU Installationsanleitung Seite 40

14. Failure handling
homeCLU automatically detects current sensor failure and loss of communication with the
charge point(s).
In the case of current sensor failure, homeCLU will go into limited operation mode.
In the case of communication loss, homeCLU will continue trying to establish
communication for 30 seconds. If communication is not re-established, the charge point
will stop charging by itself within 1-5 minutes (depending on the configuration of the charge
point). homeCLU recalculates the available current to the other charge points in use.
15. Limited operation mode
In limited operation mode, the charging current is reduced to 6A for all charge points
connected to the phase corresponding to the defective current sensor/sensor input.
16. Status indicator
40 English
Status indicator LED blinking pattern
Single blink
Double blink
Triple blink
Constant light
Constant light, single blink off
Status
Connected, not charging
Connected, charging
Programming mode
Error
Limited operation mode
www.defa.com