Homend INFINITY Benutzerhandbuch Seite 19

FILLING WITH WATER
ALWAYS remove the appliance from its power base unit when filling with water, to pre-
vent the water to be spilled out on the power base.
Do not fill with less than 0,5 liter of water or more than 2.2 liter of water.
If you attempt to boil a quantity of water below the minimum level or above the maxi-
mum level, the appliance may switch off rather early or the boiling water may eject from
the spout, respectively.
STEEPING TEA
-Unwind the power cord coiled around the power base unit of the appliance and con-
nect to a grounded socket.
It would be convenient for you to keep this unit plugged in the kitchen when not in use,
provided that the switch is turned off "O".
-Fill the kettle with water between the maximum level and the minimum level, according
to the quantity of tea you want to steep.
-Place the kettle over the power base unit.
-Open the teapot lid, take out the tea filter from its place, put an adequate amount of
tea in the filter and locate it inside of the teapot after wetting it Open by taking the main
switch to "on" and press the boiling switch. The orange pilot light will be on and the
water will start heating.
Depending upon the quantity of water put into the kettle, the water will boil within 3
to 9 minutes, boiling switch will pass automatically to the closed position and it will
decrease the heating power to keep the water boiling at the minimum level. Meanwhile
the orange pilot light will go out and the green pilot light will be on.
-Steep the tea using boiled water and relocate the teapot in its place. Add some water to
the kettle if necessary. If you add water, press the boiling switch again.
HEATING WATER
You can use the tea maker for the purpose of heating and boiling water also, if required.
After filling with water between the minimum and maximum level, place the kettle onto
the power base unit, put on the lid of the kettle, open the main switch and press the
boiling switch.