Obelink CYCLONE COMPACT Bedienungsanleitung Seite 21

5. Inflation operation
Attach the end of the air hose to the inlet or outlet of the pump (1)
and turn it clockwise to tighten. As shown in figure 1.
Attach the appropriate
turn it clockwise to tighten (step 1, figure 2). Then attach the adapter
to the valve of the inflation product (step 2, figure 2).
- Insert the 12 V plug into the ignition. (not necessary).
Usethe@ and@buttons
- Avalue can be selected
When the correct air pressure is set, the pump can be switched on
with the on/off COD switch.
IT IS NOT ALLOWED to set the maximum
the@ and —buttons
damage the pump. Switch off the pump first.
- When the maximum
immediately stops pumping.
When the pump is switched off, the 12V plug can be safely removed
from the ignition.
- Once the cable is removed, the air hose may also be unscrewed
from the pump so that everything
o
o
o
CD
Figure 1.
adapter to the other end of the air hose and
to set the desired air pressure.
from 0 to 15 PSI.
when the pump is pumping, this may
set air pressure is reached, the pump
can be stored neatly.
4
air pressure with
Figure 2.