Meterk MK08 Bedienungsanleitung Seite 2

3, Operation Instruction
(1) Turn ON/OFF:
Pressand hold "d)" button to turn on,
pressand hold again to turn off.
Turn on/off alarm function: In normal
measuring status, simply press "d)"
button to turn on the alarm,andpress
again to turn off.
(2) Dueto the electro-magneticinterferenceof
the environment, the displayreadingmay
show
-02.
(8) During measuring, press and hold
button to set-up "Auto ON" and
OFF" mode.
"OFF" means manual
"ON" means auto turn off, when no
operation, the unit will automatically shut
down within 10 minutes.
(9) During measuring, press and hold
"Mode" button to switch
(10) When the " C:) " symbol appears on
screen, please replace the battery to avoid
in-accurated reading.
(II) Alarm setting: In normal measuring status,
press and hold "MG/UT"
least for 3 seconds) to enter the Micro
Tesla Alarm Setting interface.
When the alarm value is blinking, press
C/ F button to increase value
gradually by 0.1. Press and hold to
accelerate increasing the value.
.04.
(4) H old t he tester inhand a nd move slowly
(5) Position the tester atdifferent angles tothe
(6)During m easuring,
(7)During m easuring,
"OC/OF
"Auto
turn off
on
button (at
thereading before testing, For e xample the
reading w ould lower t han0.1 gT, t hisisnot
malfunction of the tester
(3) I nnormal measuring status, press
"MG/UT"button toswitch between m G
andgT. T he default unitisPT.
towards to theobjectundermeasurement
until it isphysically t ouched. T hefield
intensity increases asyoumove c loser tothe
object.
object w hile measuring. This willaffect t he
reading. Bytryingdifferect angles
approaching theobject while measuring
get Max.
press"Mode"button to
switch between"Data Hold" and
"MaximumHold" function.
press"OC/OF"
switch between Degrees C elsius a nd
Fahrenheit.
.03.
Press "Mode" button to decreasevalue
graduallyby 0.1.Press and holdto accelerate
decreasingthe value.
Simplypress "MG/UT" button to confirm
the alarm value.
Press"d)" button to escape t he progress.
Thedefault a larmvalueis0.4PT.
(12) Zero Calibration:
In OFFstatus, pressand hold both
"d)" and "Mode" buttonuntilthescreen
displayed.
(13)Battery Installment: Openbatterydoor,
installAAA1.5V*3pcs batteriesinto the
batterycompartment p roperly, andrecover
the battery door.
4, Specification
(1) Display:4 digits
Max. Range:1999 milli Gauss,
199 micro Tesla
to
button to