3.3.
Assembling the device
Remove the packaging and then the protective film taking care not to scratch the surface.
Arrange the appliance and adjust its height and level by means of the adjustable feet – screw the feet to
the appliance as shown in the picture below:
The appliance must be earthed.
3.4.
Device use
Connect the appliance to the electricity supply.
Press the main switch on the control panel of the appliance.
The power indicator light will come on.
Turn the thermostat knob to reach the desired temperature. Turn the knob clockwise to increase the
temperature. During heating, the heating control light will be lit.
To decrease the temperature, turn the thermostat knob towards the '0' position.
To turn the heating off, turn the thermostat knob towards the '0' position - the heating is disconnected but
the unit is powered.
Avoid accumulating objects around the air circulation openings inside the unit.
To switch off the unit completely, turn the thermostat knob to the '0' position, switch off the unit with the
main switch and disconnect from the power supply.
3.5.
Cleaning and maintenance
a)
Always unplug the device before cleaning or putting it away.
b)
Use only non-corrosive cleaners to clean the surface.
c)
Use only mild, food-safe detergents to wash the device.
d)
After cleaning the device, all parts should be dried completely before using it again.
e)
Store the unit in a dry, cool place, free from moisture and direct exposure to sunlight.
f)
Do not spray the device with a water jet or submerge it in water.
g)
Do not allow water to get inside the device through vents in the housing of the device.
h)
Clean the vents with a brush and compressed air.
i)
The device must be regularly inspected to check its technical efficiency and spot any damage.
j)
Use a soft, damp cloth for cleaning.
k)
Do not use sharp and/or metal objects for cleaning (e.g. a wire brush or a metal spatula) because they
may damage the surface material of the appliance.
l)
Do not clean the device with an acidic substance, agents of medical purposes, thinners, fuel, oils or
other chemical substances because it may damage the device.
DISPOSING OF USED DEVICES:
Do not dispose of this device in municipal waste systems. Hand it over to an electric and electrical device
recycling and collection point. Check the symbol on the product, instruction manual and packaging. The
plastics used to construct the device can be recycled in accordance with their markings. By choosing to
recycle you are making a significant contribution to the protection of our environment.
Contact local authorities for information on your local recycling facility.
EN