Boffi FLAT-KAP Montageanleitung Seite 31

Fitting the tension rod kit
Downloaded from www.Manualslib.com
3
4
A
7
1
10
Sequence of procedures used when fitting the tension rod kit
A – INSERT SCREW ANCHOR (3), FIXING IT IN PLACE USING HEXAGONAL NUT
(1).
11
B – INSERT BASE (5).
C – SCREW ON THE COUPLING (6).
D – SCREW 2 HEXAGONAL NUTS (1, see detail A) ONTO THE THREADED BAR (7)
AND THEN SCREW THE BAR TIGHTLY ONTO THE COUPLING.
E – INSERT THE TENSION ROD COVER (8) AND FIX IT IN PLACE USING THE FORK
(11) AND 2 HEXAGONAL NUTS (1).
F – SCREW THE BASE (9), COMPLETE WITH ADJUSTER (10) ONTO THE FLAT KAP.
G – TAKE THE FLAT KAP AND SCREW THE ADJUSTERS (10) ONTO THE
THREADED BAR (7) UNTIL THE FLAT KAP IS LEVEL.
H – AFTER LEVELLING THE FLAT KAP, FIX EVERYTHING IN PLACE USING
HEXAGONAL NUTS (1) AND PROTECT THE ASSEMBLY USING THE TENSION ROD
COVER (8).
manuals search engine
Position Description
1 NORMAL M6 HEXAGONAL SCREW UNI 5588
2 SCREWS 3.5x16
3 M6 SCREW ANCHOR
4 WASHER FOR SCREW ANCHOR
5
5 UPPER CLOSURE BASE
6 TENSION ROD CONNECTION COUPLING
6
7 TENSION ROD
8 TENSION ROD COVER
9 BASE LOCKING FLAT HOOD TENSION ROD IN
8
PLACE
10 TENSION ROD ADJUSTER FOR FLAT HOOD
11 FORK
2
9
GB
Quantity
3
5
1
1
1
1
1
1
1
1
1