Lightning Audio Strike S4.300 Handbuch
Verfügbare Sprachen
Inhaltsverzeichnis
Verwandte Anleitungen für Lightning Audio Strike S4.300
Inhaltszusammenfassung für Lightning Audio Strike S4.300
- Seite 1 S4.300 S4.600...
- Seite 2 Thank you for purchasing the Lighting Audio Strike Amplifier. Our customers have come to expect that Lightning Audio pushes the edge in audio. Now we will push the edge in the amplifier and woofer business with high value and high performance models.
- Seite 3 SpecificAtions 4-ChAnnel Amplifiers Strike S4.300 Separate Front and Rear Power Supplies StAggered Power: 30w x 2 @ 4ohms (Front Channels) Power Rating: 90w x 2 @ 4ohms (Rear Channels) 45w x 2 @ 2ohms @ less than 1% THD (Front Channels)
-
Seite 4: Accessories
FANModule provides constant cooling over the entire transients faster than the vehicle’s electrical system. The PC board and output devices improving sound quality by POWERCell enables the Lightning Audio amplifiers to reducing distortions caused by thermal gradients. withstand the rigors of driving 2 ohm loads. -
Seite 5: Design Features
Design FeAtures Strike S4.300 Strike S4.600 - 3 -... - Seite 6 Design FeAtures A. High Level (Speaker) Inputs : The high level inputs use a detachable connector terminated with 20 AWG leads. These inputs should be used if the source unit has only speaker line (high level) outputs and not RCA outputs. B.
-
Seite 7: Installation Considerations
Adequate Length—Black Grounding Wire This section focuses on some of the vehicle considerations for installing your new Lightning Audio amplifier. Checking your battery and present sound system, as well as pre-planning your system layout and best wiring routes will save installation time. -
Seite 8: Mounting Location
Engine Compartment Mounting Lightning Audio amplifiers should never be mounted in the engine compartment. Not only will this void your warranty but could create an embarrassing situation caused by the ridicule from your friends. - 6 -... -
Seite 9: Battery And Charging
Stock electrical systems which are in good condition should be able to handle the extra load of any Lightning Audio amplifier without problems, although battery and alternator life can be reduced slightly. To maximize the performance of your Lightning Audio amplifier, we suggest the use of a heavy duty battery and an energy storage capacitor. -
Seite 10: Using Passive Crossovers
CAUTION: The Lightning Audio amplifiers are not recommended for impedance loads below 2Ω stereo and 4Ω bridged (mono) loads. - Seite 11 InstAllAtion • For safety, disconnect the negative lead from the car battery prior to beginning the installation Trunk Mounting Mounting the amplifier vertically on a surface will provide the best cooling for the amplifier. Passenger Compartment Mounting Mounting the amplifier in the passenger compartment will work as long as you provide a sufficient amount of air for the amplifier to cool itself.
- Seite 12 InstAllAtion Stereo/Mono OperAtion 4Ω min. – – 2Ω min. 2Ω min. – – 2Ω min. 2Ω min. – – 4Ω min. • RCA inputs are connected to both left and right channels. • Gain for left and right channels are set equally to balance the subwoofer. •...
-
Seite 13: System Diagrams
System DiAgrAms 2-WAy System BAND MUTE PUSH COMPACT DISC PLAYER WITH DIGITAL TUNER CD CHANGER CONTROL LOCAL LOUD DISP AS/PS MODE LOUD TRACK SCAN DISC SEEK TUNE MENU Crossover Crossover Tweeter Tweeter Midrange Midrange - 11 -... - Seite 14 3-WAy System System DiAgrAms Using Single Voice Coil Woofers BAND MUTE PUSH COMPACT DISC PLAYER WITH DIGITAL TUNER CD CHANGER CONTROL LOCAL LOUD DISP AS/PS MODE LOUD TRACK SCAN DISC SEEK TUNE MENU Crossover Crossover Tweeter Tweeter Midrange Midrange – –...
- Seite 15 3-Way System System DiAgrAms Using duAl Voice Coil Woofers BAND MUTE PUSH COMPACT DISC PLAYER WITH DIGITAL TUNER CD CHANGER CONTROL LOCAL LOUD DISP AS/PS MODE LOUD TRACK SCAN DISC SEEK TUNE MENU Front Rear Crossover Crossover Tweeter Tweeter Midrange Midrange Crossover Crossover...
- Seite 16 COMPACT DISC PLAYER WITH DIGITAL TUNER CD CHANGER CONTROL LOCAL LOUD DISP AS/PS MODE TRACK SCAN DISC SEEK TUNE MENU Front Rear Lightning Audio Woofers – – – 8Ω – – 8Ω 80Hz - 20kHz 12dB/octave HP 20Hz - 80Hz 12dB/octave LP - 14 -...
- Seite 17 4Ω – – – – 80Hz - 275Hz 12dB/octave LP ve HP 12dB/octa – 275Hz - 20kHz 12dB/octave HP Lightning Audio Woofers Lightning Audio 8Ω 8Ω 2-Channel Amplifier – – 20Hz - 80Hz 24dB octa e LP - 15 -...
- Seite 18 275Hz - 20kHz 275Hz - 20kHz 12dB/octave HP 12dB/octave HP 80Hz - 275Hz 80Hz - 275Hz 12dB/octave LP 12dB/octave LP 12dB/octave HP 12dB/octave HP Lightning Audio Woofers 8‰ Lightning Audio – – 2-Channel 8‰ Amplifier RF A-812 20Hz-80Hz 24 d B /o...
- Seite 19 275Hz - 20kHz 275Hz - 20kHz 12dB/octave HP 12dB/octave HP 80Hz - 275Hz 80Hz - 275Hz 12dB/octave LP 12dB/octave LP 12dB/octave HP 12dB/octave HP Lightning Audio Woofers Lightning Audio Woofers 8‰ 8‰ Lightning Audio Lightning Audio – – – –...
- Seite 20 - 18 -...
- Seite 21 FuncionAmiento InstAllAtion Estereo/Mono Páginas de Referencia para la Instalación 4Ω min. – – 2Ω min. 2Ω min. – – 2Ω min. 2Ω min. – – 4Ω min. • Las entradas RCA se conectan a ambos canales izquierdo y derecho • Las ganancias izquierda y derecha han de ajustarse igual para ambos canales •...
- Seite 22 NSTALACÍON • Por seguridad, desconecte el terminal negativo de la bateria antes de comenzar la instalacíon. Montaje en el Malatero del vehícule Monte el amplificador verticalmente con las orientadas de arriba hacia abajo. De esta manera conseguirá la mejor ventilación. Montaje en el Compartimento de Pasajeros El montaje en el compartimento de pasajeros sera eficiente en funcion de la ventilación que tenga el amplificador.
- Seite 23 InstAllAtion Opération stéréo/mono (tri mode) Schéma d’Installation Amplificateur de Lightning Audio 2 canaux– Français 4Ω min. – – 2Ω min. 2Ω min. – – 2Ω min. 2Ω min. – – 4Ω min. • Les entrées RCA sont connectées aux canaux gauche et droit •...
- Seite 24 NSTALLATION • Pour votre sécurité, deéconnectez la borne négative de la batterie du véhicule avant de commencer le mon- tage. Montage dans l’habitacle L’installation d’un amplificateur est envisageable dans l’habitacle dès que la convection naturelle est suffisante. Il est possible de fixer l’amplificateur soud un siège si la hauteur de celui-ci permet au minimum d’avoir trois centimètres au- dessus du dissipateur thermique.
- Seite 25 InstAllAtion Stereo/Mono Operation Installations Beiblatt 2-Kanal Lightning Audio Amplifier – Deutsch 4Ω min. – – 2Ω min. 2Ω min. – – 2Ω min. 2Ω min. – – 4Ω min. • Chinch Eingänge des rechten- und linken-Kanales anschlieben • Gain -Kontrolle gleich stellen um das Signal des Subwoofer anzugleichen •...
- Seite 26 INBAU • Zur Sicherheit klemmen Sie den Negativ-Pol der Batterie während des gesamten Einbaues ab. Im Fahrzeugkofferraum Der vertikale Einbau der Endstufen, gibt dem Verstärker die beste Kühlung. Auf der Beifahrerseite Sollte der Verstärker auf der Beifahrerseite montiert werden, so ist es sehr wichtig für eine ausreichende Kühlung zu sor- gen.
- Seite 27 InstAllAtion Stereo/Mono Operation Istruzioni di Installation Amplificatore di Lightning Audio a 2 canali – Italiano 4Ω min. – – 2Ω min. 2Ω min. – – 2Ω min. 2Ω min. – – 4Ω min. • Ingressi RCA collegati sia al canale destro sia al sinistro •...
- Seite 28 NSTALLAZIONE • Per sicurezza, scollegare il polo netativo della batteria dell’auto prima di iniziare l’installazione. Nel Bagagliaio Montando l’amplificatore su una superficie in verticale con le alette direzionate dall’alto verso il basso si garantirá un miglior raffreddamento dell’amplificatore. Nel’abitacolo Montare l’amplificatore nell’abitacolo si avrá un funzionamento regolare se si garantisce un flusso d’aria sufficiente. Per l’installazione sotto un sedile, é...
- Seite 29 SPAÑOL Veuillez contacter votre distributeur Lightning Por favor contacte al Distribuidor Autorizado Audio agréé pour toute information concernant Lightning Audio en su localidad para información les modalités de garantie et le support tech- sobre Políticas de Garantía Soporte Técnico. nique.
- Seite 30 This warranty covers only the original purchaser of Lightning Audio product purchased from an Authorized Lightning Audio Dealer in the United States. In order to receive service, the purchaser must provide Lightning Audio with a copy of the receipt stating the customer name, dealer name, product purchased and date of purchase.
- Seite 31 notes - 29 -...
- Seite 32 MADE IN CHINA Lightning Audio 955 N. Fiesta Blvd, Suite 4 Gilbert, Arizona 85233 U.S.A. In U.S.A., (480) 966-8278 08/00 M.J.T...