Flymo ELECTRIC DUMP SYSTEM Handbuch Seite 2

8 Using a 7/16" socket, remove the nut and carriage bolt that
hold the upper side bracket onto the bagger.
9 Lift up on the cross shaft and remove the upper side bracket
from the bagger.
10 Install the new upper bracket assembly from the kit by sliding
it onto the cross shaft and then align the bolt holes.
11 Using a 7/16" socket, reinstall the carriage bolt and nut to
hold in the upper bracket assembly.
Downloaded from www.Manualslib.com manuals search engine
12. Using a 3/8" socket and Phillips head screw driver, reinstall
the bagger cover and handles.
13. Route the jumper harness so that the eye loops and switch
plug are in the battery hole and the actuator plug passes
through the back plate along side of the bagger support
bracket on the left side of the tractor.
14. Reinstall the battery.
• Ensure the harness is routed over top of the battery from
the rearward, right corner.
• Connect the red wire to the positive terminal first, followed
by the black wire to the negative terminal. Ensure the
leads are flat against the battery before tightening down
the hardware.
2