Cleaning The Unit - Alessandro 45-589 Betriebsanleitung

Cleaning the unit

Do not clean the outside of the device under flowing water, simply use a damp cloth instead. Do not use any
flammable, abrasive or corrosive detergents or any sharp-edged instruments to clean the device.
Application
1. Open the lid and place the objects that require cleaning in the cleaning basket.
Then fill the container up to the mark with water.
Note: Do not use the device without water! This could damage it.
2. Close the lid and put the plug in the socket (the indicator light flashes).
3. The digital display screen shows the standard time of 180 seconds after plug-in. When you press the ON
button, the red indicator light lights up and the device starts to work. After 180 seconds the device automati-
cally switches off and the red light goes out. The display then shows the standard time again and automatically
switches off after 3 minutes without the device being in operation.
4. When you press the „SET" button, you can choose between 5 time settings: 180s, 280s, 380s, 480s, 90s.
Select the required time.
5. Press „TC", if during cleaning, heating is required (right red light comes on). Press „OFF" to stop operation.
6. Disconnect the device from the power again. Open the lid and remove the cleaned objects. Empty the container.
During cleaning, you can hear a „hissing" noise, which means that the ultrasound cleaner is working.
By repeating the cleaning phase (3 minutes), it is possible to achieve a better result.
Note: Adding soap or similar detergents into the container will improve the result. Make sure that the detergent
that you add is suitable for the objects that require cleaning and do not attack them.
In general, do not use any flammable, abrasive or corrosive detergents!
8
english
Four cleaning options
1. General cleaning
Only use tap water for general cleaning. The water should immerse the object that requires cleaning, but do
not exceed the „MAX" mark.
2. Enhanced cleaning
Warning! When the object is greasy or extremely dirty, add approx. 25-30 ml of detergent to water in order to
improve the cleaning result, the ultrasound effect is then intensified.
3. For large objects, clean in parts.
4. Extensive cleaning
If the object has to be extensively cleaned or disinfected, first use „ENHANCED CLEANING", then replace
the water and add approx. 5-10 ml of normal detergent then restart cleaning after approx. 3 minutes.
Disposal
To dispose of the packaging materials and old equipment, there is a public waste disposal system.
You can find Information about collection points from your local authority.
english
9