Product Properties; Important Safety Precautions; Areas Of Application - Alessandro 45-589 Betriebsanleitung

Operating Manual
ULTRASOUND CLEANING DEVICE
1 Lid 5
Max. Mark
2 6
Stainless Steel Tank Power Cord
3 7
Housing Plastic Basket
4
Control Panel

Product Properties

• Name: Ultrasound Cleaning Device
• Power supply: AC100-120V 60Hz / AC200-240V 50Hz
• Power: 70W
• Frequency: 42KHz
• Total size: 290x223x185mm
• Tank size: 250x150x80mm
• Volume: 2500ml
• Tot. Wgt. 2538 +/-10g
• Sturdy and quiet
• Cleaning phase can be controlled manually using the timer (1:30 – 7:30 minutes).
6
english
The ultrasound-induced vibrating water, cleans dust, grease and other dirt from jewellery, glasses and instru-
ments. Every last bit of the object is cleaned.
Before starting up the device, please read the Operating Manual through carefully and keep it safe.

Important Safety Precautions

In order to avoid electric shocks, burns, fire, personal injuries or equipment damage,
the following instructions should be observed.
• Remove the device from the mains before filling and after use.
• Use with an extension cable is not recommended.
• Never immerse the device in water or in other fluids and ensure that it does not get wet on the outside.
Therefore, never operate the device with wet hands.
• Always use the device in a dry, clean place. Ensure that the place of use is even and that the device cannot fall over.
• Never use the device without water and make sure the water fill level never exceeds the maximum mark.
• Ensure that the mains plug and your hands are dry before plugging in the mains plug.
• Never leave the device unattended during use.
• Keep the device in a place where it is not accessible to children.
• The device may not be used by children or cognitively impaired persons.
• Only use the device for the purposes described in the Operating Manual.
• Never use the ultrasound cleaning device if the mains plug or the power cord is damaged.
• When cleaning objects, only place objects in and take objects out of the device when the ultrasound function
is switched off. Never reach into the ultrasound bath when the ultrasound function is switched on.
• In order not to impair the safety, reliability and performance of the device, no extensions, new settings,
changes or repairs should be made to it.

Areas of application

For cleaning:
• Instruments: Nail drill bits, scissors, nail nippers, etc.
• Jewellery: Necklaces, rings, earrings, watch straps, etc.
• Care products: Razor blades, dentures, toothbrushes, braces, combs, etc.
Do not clean the outside of the device under flowing water, simply use a damp cloth instead. Do not use any
strong detergents. By repeating the cleaning phase (3 minutes), it is possible to achieve better results.
Note: If the object that requires cleaning has any of the following, please do not clean it in the ultrasound
device in order to avoid damage to the object: Pearls, soft gemstones, oiled stones, oiled mechanisms,
varnishes, bondings.
english
7