Robitronic R01223 Handbuch Seite 10

Specifications
RAZER eight 150A
Cont./Burst Current
Motortype
Cars Applicable
Motorlimit
Resistance
Battery
S-BEC Output
Programming-Port
Dimensions
Weight
Connection
Warning: This is a real powerful Brushless-Motor-System. For safety, remove for setup the pinion and please always
keep the wheels away from the track when switching on the ESC.
• Connecting
The #A, #B, #C wires of the ESC can be connected with the motor wires freely (without any sequence). If the
motor runs in the opposite direction, please swap any two wire connections.
• Connecting
Plug the gas channel cable on the controller into the TH / Gas channel on the receiver. The gas channel cable
outputs the voltage of 6V to the receiver and the steering servo. Be careful not to connect a separate battery to
the receiver, otherwise your ESC may be damaged.
• Connecting
Proper polarity is extremely important. Please make sure that the plus (+) is connected to plus (+) and minus (-)
is connected to negative (-) of the battery. Reversing the polarity on your regulator from the battery will damage
your regulator, which is NOT covered by the warranty!
Throttle Range Setting (Throttle Range Calibration)
In order to make the ESC match the throttle range, you must calibrate it when you begin to use a new ESC, or a new
transmitter, or change the settings of neutral position of the throttle stick, ATV or EPA parameters, etc.
The following pictures show how to set the throttle range with a FutabaTM transmitter.
R01223 // R01260 / R01261 / R01262 / R01263 / R01264
150A / 950A
Sensored / Sensorless Brushless Motor (only in sensorless mode)
1/8 Touring Car, Buggy, Truggy, Monster Truck
4S LiPo: 4274 size Motor, ≤3000KV
6S LiPo: 4274 size Motor, ≤2400KV
0,00035Ohm
3-6S LiPo / 8-18 cells NiMH
6V, 5A (The cooling fan is always working under 6V)
Fan-/Prog port on ESC
L59,5 x W48 x H42 mm
178g
the
the
the
motor:
receiver:
battery:
10