FLINQ Smart In and Outdoor String Light Premium Bedienungsanleitung Seite 3

Manuel
EN
Specifications
Wattage per lamp (16 bulbs) 0.6W
Light angle 160 degrees per side
Warm white + electrodeless RGB conversion
Product color
LED lifetime 15000 hrs
Wi-Fi APP control mode 11 function mode switching
Functional model 11 function mode switching
FlinQ APP, CBU 2.4GHZ, Wi-fi + Bluetooth BLE
Wireless connection
WIFI control distance 100M<
IP Grade
IP44
Main installation
1. Remove contents from box
Remove all the contents from the box and switch OFF the MAIN Power.
2. Connect adapter
Connect the adapter to the String Light. To do this, unscrew the cap, insert the pins
of the String light to the base connector of the adapter. Make sure the polarity+
and- connections are on the correct side as shown. Then tighten the cap to make it
waterproof.
3. Attach the string light
Attach the String Light to the desired location and use the included TY-Rips or Hooks
on each of the bulbs to fix it firmly
4. Turn on the device
Plug the power adapter into the electrical wall outlet, and switch ON the MAlN Power
Avoid danger to life by electric shock- Do not operate the unit with a damaged power
line or damaged power plug Attention! Damaged power lines represent danger to life
by electric shock Check the power lines regularly for damages and aging. If the power
line is damaged, it must be re- placed by the manufacturer, his / her representative or
FlinQ Smart In- and Outdoor String Light Premium
as similarly qualified person in order to avoid safety hazards. Protect the power line
against sharp edges, mechanical strain and hot surfaces.- Do not switch on the unit
if you notice visible damages (e.g. tears or cracks) or if you assume that the unit is
damaged (e.g, after having fallen down).
European Regulatory Notice for wireless function in Europe-Frequency Range:
-433.92 Mhz + 500 Khz
-Antenna Gain: 1.8 dBi
-Max Radio Transmission power:<10dBm
Reset device if needed
In case your Wi-Fi indicator light is not flashing rapidly follow the steps below clearly:
1. Click on "HELP" or use the FAQ inside the App.
2. Follow steps 1 till 3 until the Wi-Fi led light flashes, see below steps:1. Power ON the
device then power OFF after 10 sec and then power ON again after5 sec.
2. lf the wi-fi light is not flashing as the status as above described, please long
press the device Wi-Fi led push button for 5 - 10 seconds or longer until it flashes
correctly.
3. Confirm the indicator light is now rapidly flashing, then press "confirm indicator
rapidly blinking" button in the App.
Notes
Once the smart String Light is fully set up, turning the string light switch off and
on multiple times in a row may cause the string light to go back into reset mode. lf
that happens, please delete the string light from the app and re-add it normally as
described.