RUTEC VARDAflex RGB+WW Schnellstartanleitung Seite 2

G
RGB+WW
The LED strip is only suitable for installation in dry
indoor rooms.
Risk of electric shock!
Be sure to have a professional electrician complete
in stallation. There is no warranty coverage for any lights
installed without observing european safety directives.
Caution!
Only connect the LED strip to a suitable
power supply (24 V DC).
Only operate when completely unrolled.
Connect LED strips in parallel.
Scope of delivery
1 x 5 metre LED strip
5 x in-feed connectors
1 x direct connector
Technical data
Power supply 24 V power supply with constant
output voltage
Power 48 W
Current strength 2 A
Beam angle 120°
Quantity LED 300
Length maximum 5 metres per connection
Dimensions 5000 x 12 x 2.6 mm
Bending diameter 40 mm
Compliant with the applicable
european CE directives
Safety class 3 - low voltage protection
Suitable for indoor use only
Please refer to the respective article on www.rutec.de for
complete technical data!
Installation
Risk of electric shock!
Switch off voltage prior to installation. Ensure that voltage
cannot be accidentally switched on again.
First connect the LED strip to a controller and then
to the power supply (not included in the scope of delivery).
Caution!
On conducting surfaces, place an insulation layer between the
LED strip and surface. Surfaces must be flat, free
of dust, grease and dry.
1. Prepare surface.
2. Shorten LED strip if necessary (Fig. 1).
3. Peel off adhesive film and gently press on
LED strip, do not press directly on the LEDs.
4. Connect LED strip to power supply.
Shortening the LED strip
Risk of electric shock!
Always disconnect the mains plug before shortening.
LED strip can be separated in each case after
ten LEDs (167 mm) (Fig. 1).
example figure
Separate the LED strip at the marked position.
For a tightly assembled LED strip is a micro side cutter or an
optional cutter required.
Connecting LED strip
With direct connector:
To connect two LED strip together, use a direct
connector.
example figure
Figure 2
With in-feed connector:
To connect a
a in-feed connector.
example figure
1. Do not remove the protection film at the connection position.
2. Open the shutter of the direct / in-feed connector (Fig. 2+3).
3. Connect the in-feed connector to the end of the
LED strip (observe polarity) and close the fastener
(Fig. 2+3).
Caution!
With soldered connections note that the soldering
tem perature is 260° C and the soldering duration a
maximum of 10 seconds per soldering point.
Only use neutral cross-linked silicon (never use silicon which
includes vinegar!).
Disposal
Dispose of electrical and electronic equipment in an
environmentally friendly manner. Please contact your local
council for further information.
Figure 1
Carl-Zeiss-Str. 15
28857 Syke
G
LED strip to a power supply, use
Figure 3