Pack Contents - Nisbets Essentials Cj794 Bedienungsanleitung

• Nisbets Essentials
recommend that this
appliance should be
periodically tested (at least
annually) by a Competent
Person. Testing should
include, but not be limited
to: Visual Inspection, Polarity
Test, Earth Continuity,
Insulation Continuity and
Functional Testing.
Warning: Risk of Fire /
flammable materials
• Do not store explosive
substances such as aerosol
cans with a flammable
propellant in this appliance.
Warning: Keep all ventilation
openings clear of obstruction.
Unit should not be boxed in
without adequate ventilation.
• Warning: Do not use
mechanical devices or other
means to accelerate the
defrosting process, other
than those recommended by
the manufacturer.
• Warning: Do not damage the
refrigerant circuit.
CJ794_ML_A5_v1_20221206.indb 3 CJ794_ML_A5_v1_20221206.indb 3
• Warning: Do not use electrical
appliances inside the food
storage compartments of the
appliance.
Introduction
Please take a few moments to carefully read through
this manual. Correct maintenance and operation
of this machine will provide the best possible
performance from your Nisbets Essentials product.

Pack Contents

The following is included:
• Display Cooler
• Instruction manual
Nisbets Essentials prides itself on quality and service,
ensuring that at the time of unpacking the contents
are supplied fully functional and free of damage.
Should you find any damage as a result of transit,
please contact your Nisbets Essentials dealer
immediately.
Installation
Note: Not for use in vans or trailers, food trucks
or similar vehicles.
If the unit has not been stored or moved in
an upright position, let it stand upright for
approximately 12 hours before operation. If in
doubt allow to stand.
1. Remove the appliance from the packaging and
the protective film from all surfaces.
2. Avoid positioning the cooler in direct sunlight or
damp areas.
3. To optimize performance and longevity, ensure
a minimum clearance of 2.5cm is maintained
between the unit and walls and other objects,
with a minimum 20cm clearance on the top.
NEVER LOCATE NEXT TO A HEAT SOURCE.
4. If necessary, adjust the screw legs of the cooler
to make it level.
Note: Before using the appliance for the first
time, clean the shelves and interior with soapy
water then dry well.
EN
3
2022/12/6 10:34 2022/12/6 10:34