Lumary Smart RGB String Light Startanleitung Seite 29

2.2 Hot Spot connec�on (AP mode slowly blink connec�on)
Plug in the adapter into the socket and the bulbs will blink rapidly, please
Step 1.
long press the "on/off" bu�on 5 seconds to turn the string light to slowly
blink status. Go to step 2...
If the string light always on a�er plugging in the adapter, please long press the
"on/off" bu�on 5 seconds un�l the light bulbs suddenly don't light up, then stop
pressing the "on/off" bu�on almost at the same �me. Or power off 5 �mes un�l
the string light to quickly blink status. Go to step 2...
Open App---press "Add Device"---select "Ligh�ng"---press "Light Source
Step 2.
(BLE+Wi-Fi)".
Step 3.
confirm the light is blinking slowly.
Step 4.
Step 5. Connect your mobile phone to the device's hotspot.
Step 6. Go back to your phone's WLAN set, choose virtual router "Lumary-XXXX".
Step 7.
the APP successfully.
Note:
the string light will stop blinking, please restart step 1-7 then finish the
28