MALTEC MasterPump750W Bedienungsanleitung Seite 8

Before start-up, note the following!
The pump can be connected to any shock-proof plug which has been installed according
to regulations. The plug must have a supply voltage of 230 V ~ 50 Hz.
Attention!
(Important for your own security) Before starting to run your new submersible pump,
please have the following items checked by an expert:
 Ground connection
 Zero conductor
 Fault current breaker switch must correspond the safety regulations of the
power plants and they must work faultlessly.
 The electrical connections must be protected from moisture.
 If there is danger of flooding, the electrical connections must be taken to higher
ground.
 Circulation of aggressive fluids, as well as the circulation of abrasive materials must
be avoided at all costs.
 The submersible motor-driven pump must be protected from frost.
 The pump must be protected from running dry. Access on the part of children.
should also be prevented, with appropriate measures.
 The electrical installation shall be according to national wiring rules.
 Pollution of the liquid could occur due to leakage of lubricants the pump is to be
supplied through a residual current device (RCD) having a rated residual operating
current not exceeding 30mA.
 Children should be under close supervision to prevent them from playing with the
device.
 This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
 Children should be supervised to ensure that they do not play with the appliance.
Consistency
 Your submersible pump is designated for the circulation of water with a maximum
temperature of 35"C.
 This pump may not be used for other fluids, especially motor fuels, cleaning fluids,
and other chemical products!
Installation
The submersible pumps is installed as follows:
 In a stationary position with fixed pipeline.
 In a stationary position with a flexible hose pipe.
Please note!
 You should never install the pump by suspending it unsupported from its delivery
pipe or power cable.
8/ 18