HERA RGB Controller 24V Radio Control 75W Montage- Und Betriebsanleitung Seite 2

sse l and o e ating nst u tions
Hera RGB Controller 24V Radio Control 75W
Intended use
RGB Controller to connect to electronic safety isolating converter LED 24/...W for colour change system with
LED RGB stripes with remote control; this product is for indoor use only.
1. Disconnect from the mains supply before attempting to mount/ dismount the lighting fixture.
2. Faulty parts should only be replaced with original parts.
3. Always fully insert all plug connections.
4. Connection only to special LED - Converter Hera Type LED 24/...W with a constant output voltage
24 V DC and a maximum output power of 200 W.
5. Hera grants no warranty when other LED converters as the prescribed converters are used.
6. The total load may not exceed the nominal load of the converter.
7. The specified installation distances of the converter must be maintained.
Assembly dimensions
both LED 24 plugs must be inserted
in the 12-way distributor of the
converter
9 6
to the previous 12-way distributor of converter LED 24/...W
Assembly
1. Connect the LED converter to the mains.
2. Connect the RGB Controller to the distributor of the converter.
Point 3 - 6 are only necessary to adjust further RGB Controller to the same remote control:
3. Push the „Study Button" in the receiver with a sharpen object such as screwdriver or refill for a ballpoint pen.
The indicator lamp turns on blue.
4. Press the on/off button of the radio telecontrol for approx. 1 second. The indicator lamp flashes and turns
off.
5. After finish above steps, the indicator lamp is still on. It means learning is failed. Please repeat the process
again.
6. The LED RGB Line can now be controlled with the remote control.
Attention: After 1 Minute the wheel is locked. To unlock, press one of the 3 buttons.
A permanent flashing of the indicator lamp has no influence on the normal operation.
Remote Control
The remote control has a remote distance of max. 15m. The RGB Controller has a memory function of the performance before a
disconnection from the mains. After reestablish the mains connection the LED RGB Lines operate in the performance before the
power failure.
Do not dispose of electrical appliances in household waste, use separate collection facilities. When replacing old
appliances with new ones, the retailer is obliged by law to accept to take back your old appliance for disposal free of
charge.
Reproduction of this document in whole or part is forbidden.
5
1 6 ,
4 6
1 6
Study Button
Hera GmbH & Co. KG
®
Dieselstraße 9
32130 Enger / Germany
sse l and o e ating nst u tions
Hera RGB Controller 24V Radio Control 75W
Intended use
RGB Controller to connect to electronic safety isolating converter LED 24/...W for colour change system with
LED RGB stripes with remote control; this product is for indoor use only.
colour wheel
Gradual Change
Brightness Level
1. Flashing Change
Display 7 colours red, green, blue, purple, grey blue, yellow and white by flashing automatically and circularly.
2. Gradual Change
Change the 7 colours red, green, blue, purple, grey blue, yellow and white gradually and circularly.
3. Colour wheel
Free adjustable colour through colour wheel.
Attention: After 1 Minute a beep is emitted. The colour wheel is locked. To unlock, press one of the 3 buttons.
4. Brightness Level
The brightness of the LED RGB Lines is dimmable in four steps. Holding down the button Gradual Change until a beep is emitted
will decrease the brightness in increments. Keep the button pushed and rotate the Colour wheel to change the brightness.
An anti-clockwise rotation of the colour wheel for higher brightness or a clockwise rotation for lower brightness.
5. Colour Change Speed
The period of a colour loop can be adjusted to 8, 16, 32, 64 or 128 seconds. To change the speed hold down the button Flashing
Change until a beep is emitted. Keep the button pushed and rotate the Colour wheel to change the speed.
An anti-clockwise rotation of the colour wheel for faster change speed or a clockwise rotation for slower change speed.
Installation of the Battery
Lithium Batterie
CR2032 3V
Declaration of Conformity:
Hera GmbH & Co. KG declares that the product „ Hera RGB Controller 24V Radio Control" corresponds to the directive 2014/53/EU.
The full text of the EU-Declaration of Conformity is available on the following internet address:
http://www.hera-online.de/en/technical-information/declaration-of-conformity.html
Battery safety:
- Never attempt to recharge non-rechargeable batteries.
- Insert batteries correctly, observing plus (+) and minus (-) markings.
- Battery contacts should not be short-circuited.
- Only use batteries which match the recommended battery type or correspond to this type.
- Do not throw batteries into a fire as they could explode.
- Dispose of batteries safely.
Do not throw batteries in the household waste (!)
Used batteries/ rechargeable batteries should not be disposed of with normal household waste. As a consumer, you are
obligated to dispose of used batteries / rechargeable batteries at a municipal collection point or local store, where it is
free of charge. The symbol of a waste container on your batteries / rechargeable batteries with a line through it means
that the batteries should not be disposed of with normal household waste. The symbol below the waste container
stands for Pb: Battery contains lead, Cd: Battery contains cadmium, Hg: Battery contains mercury.
Reproduction of this document in whole or part is forbidden.
Flashing Change
Colour Change Speed
On / Off
When turn on the last switching status is
recovered (Memory-Function)
To preserve the remote control use the enclosed
holder. The holder can be glued with adhesive sheet or
fastened with screws.
Hera GmbH & Co. KG
®
Dieselstraße 9
32130 Enger / Germany