GCE FIT+ Gebrauchsanweisung Seite 2

ENGLISH
INSTRUCTION FOR USE: MACHINE CUTTING TORCH
EN
The purpose of this operating manual is to enable the torches to be used safely
and properly, according to regulations. Reading and observance of the operat-
ing manual helps to avoid hazards prevent downtimes and increases the relia-
bility and service life of the equipment.
The Operating manual must be available ready for use during operation.
Safety information, see also section 3.
In case of doubt please consult the manufacturer.
1. DESCRIPTION
1.1. DESCRIPTION OF THE MODEL TYPE
The machine cutting torches are designed either with injector mixing system
or with the system of mixing in the nozzle (nozzle mix).
They conform to the requirements of EN ISO 5172 and are produced and tested
according to current engineering guidelines. The machine cutting torches with
"A" marking shall be used with acetylene as a fuel gas and torches with "P"
marking shall be used with fuel gases propane, propylene, ethylene, natural gas
(methane), propane-butane, LPG and methyl acetylene/propadiene mixtures.
2. APPLICATION
2.1. PROPER USE ACCORDING TO GUIDELINES
2.1.1. The machine cutting torches must only be used for fl ame (oxygen) cutting
on fl ame (oxygen) cutting machines! The following GCE cutting nozzles can be
used in connection with the torches:
CUTTING TORCH
FIT+
BIR+
FIT,
Jetstream,
BM31
Injector A
PMY
Injector A
PMY
Injector A
PMY
Y
CUTTING NOZZLES
ASF
PSF
AC ASD
PUZ PSD
MA133
MP133
MY133
2/120
ARC
PRC
AHD
PHD
JETEX
PROPEX
PROPEX